Axon Fleet Hızlı Başlangıç Kılavuzu

Dijital Kamera Axon Fleet için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Axon Fleet 2 sayfaları.

Sayfayı Yazdır
Axon Fleet Camera System Quick Start Guide
English (U.S./Canada/Australia/U.K.)
Axon Fleet Hardware
1
2
8
3
6
4
7
5
camera front
camera back
mount and camera
mount without camera
front
Axon Fleet power unit
Read, understand, and follow all current instructions, warnings, and relevant Axon training materials before using any Axon system. The
most up-to-date warnings and instructions are available at www.axon.com.
Recording
The Axon Fleet camera system has 2 operating modes. The default
mode, or BUFFERING mode, provides pre-event buffering to cap-
ture activities that occur before you activate the EVENT (recording)
mode.
Note:
The Axon Fleet camera will not operate outside of its mount.
1
Turn the system on. Move the ON/OFF switch to the ON position.
•
The camera takes a few seconds to boot up and be ready to
10
camera top
11
camera bottom
12
mount and camera
front
back
!
WARNING! FOLLOW SAFETY INSTRUCTIONS
Axon Fleet Features
1. Camera lens
9
2. Power switch (red = On/BUFFERING mode)
3. Speaker
4. Battery LED (green = 41–100%; yellow = 20–40%; red = less than
20%)
5. Microphone
6. EVENT button (press = start recording; hold 3 seconds = stop re-
cording)
7. Battery status button: (push to show status of battery)
8. Operation LED
9. Function LED
4
10. Dataport (data transfer through PC or Axon Dock)
11. Upload status LED
F
12. Carriage bolt (allows tilting the camera to the desired angle, and
then fixing the camera in place)
E
D
C
The camera can be tilted 90 degrees in 10-degree increments
Note:
Move the ON/OFF switch to the OFF position before
removing the camera from the mount.
B
UNLESS OTHERWISE SPECIFIED:
FINISH:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
SIGNATURE
DATE
NAME
DRAWN
CHK'D
record (the red area under the switch will be exposed with the
APPV'D
A
switch moved to the ON position).
MFG
Q.A
•
The operation LED will be solid red and then transition to
blinking green when the system goes into BUFFERING mode.
4
3
2
DEBURR AND
DO NOT SCALE DRAWING
BREAK SHARP
EDGES
TITLE:
MATERIAL:
DWG NO.
instructional assembly
WEIGHT:
SCALE:1:2
3
2
Solid Red
Blinking Green
Boot up mode
BUFFERING mode
1
F
E
D
C
B
REVISION
A
A4
SHEET 1 OF 1
1