AccuPel HDG-4 Kullanıcı Kılavuzu - Sayfa 4

Uzaktan Kumanda AccuPel HDG-4 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AccuPel HDG-4 11 sayfaları.

HDG-4000 ANALOG/DIGITAL VIDEO CALIBRATION GENERATOR

IR Remote Control Functions

The AccuPel HDG-4 IR (Infrared) Remote Control provides selection of all calibration patterns, signal

settings, and special modes of the AccuPel HDG-4000 Analog/Digital Video Calibration Generator. It is also

used to select settings in the HDG-4000 On-Screen Display (OSD) menu.

The HDG-4000 Format LEDs flash each time an IR remote control command is received. If an invalid

remote control command is received, the Format LEDs will blink rapidly 4-times.

Output Selection

Directly select the Output type for analog and digital video

signals.

YPbPr - Selects YPbPr analog signals (without 7.5 IRE black-

level setup), and 4:4:4 YCbCr digital signals.

YPbPrs - Selects YPbPr analog signals with 7.5 IRE black-level

setup, and 4:2:2 YCbCr digital signals.

RGB-V - selects RGB analog signals (without 7.5 IRE setup),

and RGB digital signals with standard digital video levels (digital

level 16 for black and digital level 235 for 100% reference white).

RGBs-PC - selects RGB analog signals with 7.5 IRE setup, and

RGB digital signals with PC digital video levels (digital level 0 for

black and digital level 255 for 100% reference white).

Y/C - Selects Y/C (S-video) analog signals from the 4-pin mini-

DIN connector.

CVBS - Selects CVBS (composite video) analog signals from

the 4-pin mini-DIN connector.

Note: The 7.5 IRE black-level setup on NTSC (480i) Y/C and

CVBS signals can be disabled in the OSD menu. PAL (576i) Y/C

and CVBS signals never have black-level setup.

Sync Selection

Pos, Neg, SoG – selects positive or negative analog RGB HV

sync polarity, or analog RGB signals with embedded sync-on-

green.

Note: HV sync polarity for digital signals is set according to the

EIA/CEA-861-B standard. But the digital HV sync polarity can be

overridden in the OSD menu. HD YPbPr signals and HD analog

RGB signals with SoG have Tri-level embedded sync, while SD

analog signals have Bi-level embedded sync. Bi-level embedded

sync can also be selected for HD analog signals in the OSD

menu.

HDG-4 USER MANUAL