ARC Audio KS125.2 MINI Kurulum Talimatları Kılavuzu - Sayfa 15
Amplifikatör ARC Audio KS125.2 MINI için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. ARC Audio KS125.2 MINI 17 sayfaları. Moto series
Sayfayı Yazdır
Crossover and Level Setting Instructions
Stereo Fullrange or Highpass
2 or 4 ohms
WARNING!!!!!!
YOU MUST TURN OFF YOUR
MOTORCYCLES AUTOMATIC
VOLUME CONTROL (AVC)
WHEN USING ANY MPAK
KIT KIT. FAILURE TO DO
SO CAN RESULT IN
DAMAGE TO THE EQUIP-
MENT AND TO YOUR LIS-
TENING EXPERIENCE!!
Crossover Setting and Adjustment-
Adjustment of your amplifiers
built in crossover is one of the two
most important steps in properly
setting up your new audio addition.
As per figure LS1, locate the cross-
over output selection switch and
with a small screwdriver carefully
move it into the "High" Position.
Then find the crossover frequency
selection dial and turning clockwise
from the factory setting, turn the
dial till it is aligned just before
the "110" marking on the dial.(See
Figure LS2)
Setting Gains-
When setting the gains for the
amplifier be careful when making
the adjustments as to not twist or
break the adjustment knobs.
When looking closely at the
adjustment dial you will notice a
raised indicator, this will tell
you the exact adjustment point of
the gain dial.
Turn both adjustments up till
the indicator is just past vertical
and pointing between the "A" & "I"
on the writing on the word "Gain"
above the top dial (See Figure LS3)
Then visually match the setting
on the right channel gain to the
same as the left channel gain as
indicated on Figure LS3
Factory equipment notice
HD factory radio's have been known
to clip (or distort) at higher oper-
taing levels. ARC Audio recommends,
but does not require that operation
of the HD factory radio not be done
at levels any higher than four bars
from Maximum volume to optimize you
experience and to ensure you the
highest level of dynamic sound qual-
ity and performance possible.
Figure - LS1
Set to this
point as
indicated.
Figure - LS2
Set Gains
as shown
Figure - LS3
-