Axor Citterio 39144XX1 Kurulum Kılavuzu - Sayfa 3

İç Mekan Mobilyaları Axor Citterio 39144XX1 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Axor Citterio 39144XX1 8 sayfaları. Faucet

Remove the inserts from the hot and

cold plaster shields.

Cut the plaster shields so that they

extend 1/16" from the wall. Seal

around the shields with a suitable,

non-staining, waterproof bathroom

sealant.

Lever handle version only:

Remove the hot and cold

cartridges using a 17 mm deep

socket wrench. Replace them

with the 1⁄4 turn ceramic cartridges

included with the trim kit. The hot

cartridge is marked with notches

on the wrench flats.

On the spout outlet, measure the

distance from the brass rough-in

to the end of the plaster shield.

Record this measurement ("X").

Add 1 7/8" to this measurement.

Measure the spout adapter. Mark

a point X + 1 7/8" from the o-

ring end of the adapter. Cut the

adapter at this point.

Wrap the threads with several

layers of Teflon® thread tape.

Screw it into the spout port.

Measure the distance from the

plaster shield to the end of the

spout adapter. It should measure

1 3/8".