AXTON A400 Kurulum ve Kullanım Kılavuzu - Sayfa 5

Amplifikatör AXTON A400 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. AXTON A400 17 sayfaları. 1-/2-/4-/5-channel power amplifiers

Sayfayı Yazdır

1. CONNECTIONS + CONTROLS A500 - PAGE I

SIGNAL INPUTS FRONT R / L and REAR R / L

Front and Rear channel Low-level stereo RCA signal or high-level speaker signal input

terminals for connection to head-unit.

INPUT GAIN CONTROL FRONT CHANNELS

Input gain potentiometer for channel FL/FR-CH, to match the output voltage of the head

unit to the amplifier's input.

OPERATION MODE SWITCH FRONT CHANNELS

Slide switch to select the operation mode of the X-over for section FL/FR-CH of the

amplifier: 50 Hz Highpass or full signal.

BASS LEVEL REMOTE CONTROL INPUT

Input terminal to connect the external bass level remote to the amplifier.

INPUT SIGNAL SELECTION

Slide switch to select the input signal for all channels. "2-CH" to use only front input

terminal for all output channels. "5-CH" to give each output channel its corresponding

input channel (the CH 5 is summarized by all 4 input channels).

OPERATION MODE SWITCH REAR CHANNELS

Slide switch to select the operation mode of the X-over for section RL/RR-CH of the

amplifier: 50 Hz Highpass or full signal.

INPUT GAIN CONTROL REAR CHANNELS

Input gain potentiometer for channel RL/RR-CH, to match the output voltage of the head

unit to the amplifier's input.

POWER LED

LED to show the operating status of the amplifier by blue/red illumination. Blue is

normal working state, red is protect mode of amplifier.

AUTO-TURN-ON MODE

Slide switch to select the auto-turn-on function: REM by remote wire, VOX to switch on

by music signal or DC by DC offset signal of the head units integrated amplifier.

10 LOWPASS FREQUENCY CONTROL SUBWOOFER CHANNEL

Control potentiometer to adjust the lowpass filtering frequency point of the subwoofer

output channel.

11 INPUT GAIN CONTROL SUBWOOFER CHANNEL

Input gain potentiometer for subwoofer channel, to match the output voltage of the head

unit to the amplifier's input.

12 INPUT MODE SELECTION

Switch to select the proper input sensitivity range: RCA signal input = Low. Speaker

signal input = Hi.

13 SPEAKER OUTPUT TERMINAL

Output terminal to connect the speakers to the amplifier in either stereo or bridged

mode.

– 8 –

1. CONNECTIONS + CONTROLS A500 - PAGE II

14 "+12 V" POWER INPUT TERMINAL

Terminal to connect the amplifier to the positive +12V pole of the car battery.

15 "REM" INPUT TERMINAL

Terminal to connect the amplifier to the automatic (remote) turn-on / turn-off lead of the

head unit. You must switch 9 to "REM" when using the remote wire input terminal.

16 "GND" POWER INPUT TERMINAL

Terminal to connect the amplifier to the chassis ground or negative pole of the car

battery.

2 3

Auto Turn On

105.0 mm

– 9 –

bn 1