AXTON A542DSP Kurulum ve Kullanım Kılavuzu - Sayfa 8
Amplifikatör AXTON A542DSP için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. AXTON A542DSP 20 sayfaları. 4-channel smart digital amplifiers
Sayfayı Yazdır
Gain Phase
In this menu you can adjust the following
settings for each individual channel: sound
level, mute and phase. The sound level
settings adjust in the field above and under
the respective speaker icons.
In the lower area of the menu, in the top
line, are the icons for phase-settings. From
left to right: Front left, Front right, Rear left,
Rear right, Subwoofer.
In the bottom line are the icons for setting
the mute switch. From left to right: Front
left, Front right, Rear left, Rear right, Sub-
woofer.
When you adapted the settings, go back to
the main menu, and touch the „Save to Am-
plifier" button
to transfer the settings to
the amplifier. During the saving process do
not switch off the amplifier as this may lead
to malfunction and/or damage. You can
also save the settings on your smartphone.
To do this, press „Save on Phone"
and enter the desired filename.
Noise Gate
In the upper right corner of the GAIN menu
you can find the Noise Gate function. It's
intended to reduce the back ground noise
of the head unit. If back ground noise of
the head unit is audible, increase the Noise
Gate level by sliding to the left until the
noise disappeared.
Noise Gate
function top right
,
Gain Phase
Gain Phase
– 14 –
Crossover
In this menu you can assign a frequency
band to the connected speakers that cor-
responds to their recommended operating
range. You can choose to adjust each
channel separately, combine front and rear
speakers and also all speakers together.
In the left half of the diagram you can set
the break frequency of the high pass filter
as well as its slope. In the right half are the
break frequency and slope of the low pass
filter. The blue line shows the set slope
of the filter. „Bypass" means the signal is
unfiltered and contains all frequencies.
The filter settings also apply to the
corresponding preamp outputs.
When you adapted all settings, go back
to the main menu, and touch the „Save to
Amplifier" button
to transfer the set-
tings to the amplifier. During saving do not
switch off the amplifier as this may lead to
malfunction and/or damage. You can also
save the settings on your smartphone. To
do this, press the „Save on Phone" button
, and enter the desired filename.
Crossover
– 15 –