Arcam P90/3 El Kitabı - Sayfa 7

Amplifikatör Arcam P90/3 için çevrimiçi göz atın veya pdf El Kitabı indirin. Arcam P90/3 15 sayfaları.

Arcam P90/3 El Kitabı

Recording

With the Arcam A90 it is possible to listen to and record from
one source, or to listen to one source while recording another.
Both sets of tape sockets are identical in sensitivity and suitable
for use with almost any type of recorder (cassette, CDR, MD,
VCR, reel-to-reel, etc.). The record signal is sent to both the
and
output sockets.
TAPE
VCR
RECORD
bk
To record the currently selected source, press
RECORD SOURCE
the display shows '
display reverts to showing the volume level and you are ready
to record.
To listen to one source while recording another, press
RECORD
again until the display shows '
AUX
CD
TUNER
of an input (e.g. '
', '
', '
source selector button on the front panel for the source you
wish to record. Your selection is shown on the display for a few
seconds, after which it reverts to showing the volume level and
you are ready to record.
The
button can also be used as a second zone
RECORD
selector, sending a source signal at line level to a second
amplifier operating in another room. If you need help with this,
contact your Arcam dealer or Arcam customer support.
Tape-to-tape copying (dubbing)
You can perform tape dubbing from
to
.
TAPE
VCR
For example, to copy from a cassette recorder connected to
the VCR socket to a cassette recorder connected to the TAPE 1
socket, first use the
button as explained above and
RECORD
RECORD VCR
select '
'. This routes the VCR signal to the TAPE
output.
Set the cassette recorder connected to the
record mode and the other to playback mode to start dubbing.
TAPE
5
To play back the recording from a cassette deck attached to
TAPE 1
the TAPE 1 input, press
. '
TAPE
Selecting this input overrides the other source selectors.
It is also possible to monitor a recording while it is being made,
provided your cassette deck is a 3-head type. To do this, press
. Switching this button in/out allows an A/B comparison
TAPE
between the source signal and the recorded signal.
until
RECORD
'. After a few seconds the
RECORD
' followed by the name
', etc.). Now press the
to
, but not from
VCR
TAPE
socket into its
TAPE
' is shown on the display.
A90/P90
7