AXTON A590DSP Kurulum ve Kullanım Kılavuzu - Sayfa 7

Araba Amplifikatörü AXTON A590DSP için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. AXTON A590DSP 17 sayfaları. 4-channel smart digital amplifiers

Sayfayı Yazdır

Gain Phase

In this menu you can make the following

settings for each individual channel: sound

level, mute and phase. The sound level set-

tings are made in the field above and under

the respective speaker icons.

In the lower area of the menu in the top line

are the icons for setting the phase. From

left to right: Front left, Front right, Rear left,

Rear right, Subwoofer.

In the bottom line are the icons for setting

the mute switch. From left to right: Front

left, Front right, Rear left, Rear right, Sub-

woofer.

When you have done the settings, go back

to the main menu, and touch the „Save

to Amplifier" button

to transfer the

settings to the amplifier. During the sav-

ing process do not switch off the amplifier

as this may lead to malfunction and/or

damage. You can also save the settings on

your smartphone. To do this, press „Save

on Phone"

, and enter the desired

filename.

Noise Gate

In the upper right corner of the GAIN menu

you can find the Noise Gate function. It's a

dedicated to reduce the back ground noise

of the head unit. If back ground noise of

the head unit is audible, increase the Noise

Gate level by sliding to the left until you

cannot listen the noise anymore.

Noise Gate

function top right

Gain Phase

– 12 –

Crossover

In this menu you can assign a frequency

band to the connected speakers that cor-

responds to their recommended operat-

ing range. You can chose to adjust each

channel separately, combine front and rear

speakers and also all speakers together.

In the left half of the diagram you can set

the break frequency of the high pass filter

as well as its slope. In the right half are the

break frequency and slope of the low pass

filter. The blue line shows the set slope of

the filter. „Bypass" means that the signal is

unfiltered and contains all frequencies.

The filter settings also apply to the corre-

sponding preamp outputs.

When you have done all settings, go back

to the main menu, and touch the „Save

to Amplifier" button

to transfer the

settings to the amplifier. During the saving

process do not switch off the amplifier as

this may lead to malfunction and/or dam-

age. You can also save the settings on your

smartphone. To do this, press the „Save on

Phone" button

, and enter the desired

filename.

Crossover

– 13 –