Circe Cycles Helios STEPS Montaj Kılavuzu - Sayfa 4
Bisiklet Circe Cycles Helios STEPS için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. Circe Cycles Helios STEPS 8 sayfaları.
Ayrıca Circe Cycles Helios STEPS için: Kullanıcı El Kitabı (15 sayfalar)
Sayfayı Yazdır
• 15mm pedal spanner
• Di2 tool (STEPS Triplet) supplied
• Long nose pliers or chainlink pliers (Triplet)
INSTALLING STEERER EXTENDER
The steerer extender fits to the top of the fork and
locates on the 4-pointed star, the slot at the back
of the extender should align with the vertical slot on
the side of the top cap.
Ensure the steerer is fully pushed down before
tightening the Q/R.
Fit the handlebar to the stem using an Allen key
and tighten according to the torques settings in the
torque table Appendix A.
4
Extender
Top cap
CirceCycles.com
INSTALLING FRONT WHEEL
The front wheel is fitted using a thru axle, that is
pushed through from the left side of the bike (disc
brake side) and then tightened using a 6mm Allen
key. When installing the wheel make sure the disc
rotor is aligned between the pads, before pushing
the wheel into the fork ends.
NOTE – with hydraulic brakes, first remove the
orange pad spacer before installing the wheel.
INSTALLING FRONT MUDGUARD
The front mudguard attaches in three places; the
fork crown and hte bottom of each fork leg. You
will need a 6mm Allen key and 10mm spanner to
fasten the bolt at the fork crown and a pair of pliers
to help insert the stays into the plastic clips, though
this can be done by hand.
you have a front light or Hebie steering stabaliser
you will have to attach these at the fork crown with
the mudguard.
If