Arcan HJ1800AU Hızlı Başlangıç Kılavuzu

Jacks Arcan HJ1800AU için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Arcan HJ1800AU 6 sayfaları. 1,800 kg aluminum-steel hybrid jack

Sayfayı Yazdır

Warning information

This is the safety alert symbol. It is used to alert you

to potential personal injury hazards. Obey all safety

messages that follow this symbol to avoid possible

injury or death.

imPortant: rEaD tHESE inStrUCtionS BEforE oPErating

BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING

PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.

It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsiblity of the

device owner to keep this manual intact and in a convenient location for all to see and read. Contact Arcan for a replacement label if your

jack's label is not readable.

tHE natUrE of HaZarDoUS SitUationS

WARNING

The use of Portable Automotive Lifting Devices are subject to certain hazards that cannot be prevented by mechanical means, but only

by the exercise of intelligence, care, and common sense. It is essential to have personnel involved in the use and operation of the device

who are careful, competent, trained, and qualified in the safe operation of the device and its proper use when servicing motor vehicles

and their components. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads,

overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not intended.

mEtHoDS to aVoiD HaZarDoUS SitUationS

WARNING

• The unlifted wheels of the vehicle should be chocked.

• Load should be centrally located on the head cap.

• No person should remain in a vehicle that is being lifted.

• Vehicle manufacturer owners manual should be consulted prior to lifting of vehicle.

• The hydraulic jack should be used for lifting and lowering only.

• Use only high quality hydraulic oil.

• Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid, or unstable

due to loose or missing components. Make corrections before using.

• Lift only on areas of the vehicle as specified by the vehicle manufacturer.

• Wear eye protection that meets ANSI Z87.1 and OSHA standards.

• Do not use jack beyond its rated capacity.

• This is a lifting device only. Immediately after lifting, support the vehicle with jack stands capable of sustaining the load before working

on the vehicle.

• Use only on a hard level surface free from obstructions so the jack is free to reposition itself during lifting and lowering operations.

• Center load on saddle. Be sure setup is stable before working on vehicle.

• Do not move or dolly the vehicle while on the jack.

• Do not use saddle adapters or saddle extenders between the stock lifting saddle and the load.

• Do not use any adapters unless approved or supplied by Arcan.

• Always lower the jack slowly and carefully.

• Failure to heed these warnings may result in fatal personal injury and/or property damage.

ConSEQUEnCES of not aVoiDing HaZarDoUS SitUationS

WARNING

Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,

MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS

could cause accidents resulting in serious or fatal personal injury and/or property damage.

1,800 kg Aluminum-Steel Hybrid Jack

For Technical Questions, Call: 1-800-879-7316

WARNING

Model HJ1800AU

WARNING: Indicates a hazardous situation

which, if not avoided, could result in death

or serious injury.

rev. 041814