Digicom 8 PORT 100 Kullanıcı Kılavuzu - Sayfa 15

Anahtar Digicom 8 PORT 100 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Digicom 8 PORT 100 19 sayfaları. 8 port switch or hub

8 port 10/100

2. INSTALLATION

The device can be placed on flat surfaces or desktops.

Once you have decided the installation place, please verify that there is enough space and

ventilation, and that the operating temperature and humidity ranges are respected.

Also be sure that all the necessary cables are near enough to permit a safe and clean

connection to the device ports.

Place the device on a firm flat space on your desktop.

If you are stacking more devices, be careful and avoid situations which could cause instability

or damages to persons or to the devices themself.

The device has several RJ-45 ports that support connection to switch, hub or stations

running

100Mbps.

transmission speed is

automatically set by the

device to match the

speed supported by the

other device using auto-

negotiation (if supported

by the attached device).

Use 100 Ohm RJ45-

RJ45 UTP (Unshielded

Twisted Pair) or STP (Shielded Twisted Pair) cables.

Use 100 Ohm RJ45-RJ45 UTP (Unshielded Twisted Pair) or STP (Shielded Twisted Pair)

straight cables to connect to network cards. Use crossed cables to connect to another

switch or hub. See section "Cable wirings" for more details.

Use Category 3, 4, or 5 cables for 10Mbit/s connections. Use Category 5 cables for 100Mbit/

s connections. The maximum length for the cables is 100meters (328 feet).

Uplink

The device supports Auto MDI/MDI-X function, It will auto-detect the cable type when it

plug into Switch, and it means all ports can be use as Uplink port, and no need to use a

cross-over cable for uplink to other hubs or switches.

When inserting an RJ-45 plug, be sure the tab on the plug clicks into position to ensure that

it is properly seated.

The

Installation