Axxess GMOS-LAN-09 Kurulum Talimatları - Sayfa 2

Kayıt Ekipmanları Axxess GMOS-LAN-09 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Axxess GMOS-LAN-09 4 sayfaları. Lan-29 data interface 2014-up
Ayrıca Axxess GMOS-LAN-09 için: Kurulum Talimatları (4 sayfalar)

Sayfayı Yazdır

From the 16-pin harness with stripped leads to the aftermarket radio:

• Connect the (2) Red wires to the accessory wire.

Note: If installing the ASWC-1, there will be an accessory wire in the

12-pin harness to connect as well.

• Connect the Orange/White wire to the illumination wire. If the aftermarket

radio has no illumination wire, tape off the Orange/White wire.

• Connect the White wire to the left front positive speaker output.

• Connect the White/Black wire to the left front negative speaker output.

• Connect the Gray wire to the right front positive speaker output.

• Connect the Gray/Black wire to the right front negative speaker output.

• Connect the Blue/White wire to the amp turn-on wire.

Note: This wire must be connected to turn the interface on.

• Connect the Brown wire to the mute wire. If the aftermarket radio does not

have a Mute wire, tape up the Brown wire. If the Brown wire is not connected,

the radio will turn off when OnStar is activated.

The following wires are for the aftermarket radios that have navigation built in:

• Connect the Light Green wire to the parking brake wire (if applicable).

• Connect the Blue/Pink wire to the speed sense wire (if applicable).

• Connect the Green/Purple wire to the reverse wire (if applicable).

GMOS-LAN-09

Connections to be made

From the GMOS-LAN-09 harness:

(a) 16-pin harness to the aftermarket radio:

(b) 22-pin harness to the aftermarket radio:

(c)

• Connect the Yellow wire to the 12-volt battery wire.

• Connect the Black wire to the ground wire.

• Connect the Green wire to the left rear positive speaker output.

• Connect the Green/Black wire to the left rear negative speaker output.

• Connect the Purple wire to the right rear positive speaker output.

• Connect the Purple/Black wire to the right rear negative speaker output.

• The Black/Yellow wire is for the OnStar volume adjustment. This will be

discussed in the OnStar Level Adjustment section of this instruction.

• The DIN connector is for use with the optional AX-LCD (sold separately). This

will give you the option of changing the settings in your personalization menu.

20-pin harness to the aftermarket radio:

•

Connect the White RCA to the aftermarket radio's left Audio AUX in.

• Connect the Red RCA to the aftermarket radio's right Audio AUX in.

Note: To retain the factory 3.5mm jack, the radio must have an Audio AUX in.