Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO Kullanıcı Kılavuzu - Sayfa 13

Yazıcı Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO 17 sayfaları. 24-pin dot matrix printer
Ayrıca Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO için: Kullanıcı Kılavuzu (22 sayfalar), Hızlı Referans (12 sayfalar), Teknik Özellikler (2 sayfalar), Teknik Özellikler (3 sayfalar), Referans Kılavuzu (34 sayfalar), Kurulum Kılavuzu (2 sayfalar)

Sayfayı Yazdır

Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO Kullanıcı Kılavuzu

Installing or Replacing the Ribbon

Cartridge

EPSON recommends using genuine EPSON Ribbon

Cartridges (S015016).

You may need to touch the print head when you

install or replace the ribbon cartridge. If you have just

used the printer, the print head may be hot; let it cool

for a few minutes before proceeding.

1. Make sure the printer is turned off.

2. Open the printer cover.

3. The print head should be in the ribbon replacement

position, as shown below. It should be aligned with the

indentation in the front metal plate.

indentation

If it is not, close the printer cover and turn the printer on to

move the print head to the ribbon replacement position.

Wait a few seconds, then turn the printer off again and open

the printer cover.

Following the steps below while the printer is turned on

can damage the printer.

4. If a used ribbon cartridge is already installed, squeeze the

tabs on each side of the cartridge, and pull the cartridge out

of the printer. Discard the used cartridge.

5. Remove the new ribbon cartridge from its package and turn

the ribbon-tightening knob in the direction of the arrow to

take up any slack in the ribbon.

6. Hold the ribbon cartridge with the exposed ribbon down

and the ribbon-tightening knob facing you, and guide the

ribbon under the print head. Then snap the cartridge into

place so that the tabs on both sides of the cartridge fit into

the notches in the cartridge holder.

7. Hold the ribbon cartridge by its handle and push it firmly

down into position; then press on both ends of the cartridge

to make sure the plastic hooks fit into the slots.

11/00

EPSON LQ-680Pro