Axxess AX-ADDCAM Kurulum Talimatları Kılavuzu - Sayfa 5
Otomobil Elektroniği Axxess AX-ADDCAM için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Axxess AX-ADDCAM 8 sayfaları. Camera switching interface
Sayfayı Yazdır
CONFIGURING THE AX-ADDCAM
Video trigger description
• Backup camera: Dedicated by default to Video Trigger 1. Will activate the backup camera
while the vehicle is in reverse.
• Left blinker: Activation of the left turn signal will activate the left camera. *
• Right blinker: Activation of the right turn signal will activate the right camera. *
• Auto (reverse -> drive): Available only for Video Trigger 4, when installing a front camera. With
this feature selected, the camera will activate automatically once a reverse-then-drive sequence
is seen from the vehicle. Example of this scenario would be while parallel parking the vehicle. As
an alternative, a control wire can be used instead to manually activate the camera .
Note: Auto (Reverse -> Drive) will disable the camera once 15 MPH is reached. A control wire
activated will also disable the camera.
Note: If the control wire is activated while driving, the camera will activate and deactivate
during stop-and-go traffic.
• Control 1-4 (positive or negative) trigger activation wires: Can be used as a positive or
negative trigger to manually activate a camera via a toggle switch, or similar device.
* Not available for Fords with a 4-inch display screen radio.
Other settings
Switched 12V with
• Disable: On by default.
• Accessory Out: 12-volt out when
CAN data is detected.
• Camera Active: 12-volt out if a camera
has been activated.
(CONT.)
VSS out Function
• Disable: On by default.
• Camera Active: Active while camera is on.
INSTALLING THE AX-ADDCAM
With the key in the off position:
• Connect the AX-ADDCAM harness into the interface, and then to the "Plug & Play" harness
(sold separately).
• Connect the "Plug & Play" harness (sold separately) to the wiring harness in the vehicle.
Note: If the "Plug & Play" harness (sold separately) includes any secondary harnesses, connect
those as well.
• Connect the cameras to the appropriate RCA jacks.
REV. 5/3/2018 INSTAX-ADDCAM
5