DigiDesign 96 I Manuel - Sayfa 13

Kayıt Ekipmanları DigiDesign 96 I için çevrimiçi göz atın veya pdf Manuel indirin. DigiDesign 96 I 19 sayfaları. Version 8.0

Expansion Port

The Expansion Port is used to connect an addi-

tional Pro Tools|HD I/O to the 96 I/O. This port

is only available when the 96 I/O is connected

to a Pro Tools|HD card (it is not available when

the 96 I/O is connected to the Expansion Port

on another audio interface).

Legacy Port

The Legacy Port is used to connect qualified

Pro Tools|24 MIX-series Digidesign audio inter-

faces to the 96 I/O. You can connect two eight-

channel interfaces (such as the 888|24 I/O™ or

882|20 I/O™) or a single sixteen-channel inter-

face (1622 I/O™ or 24-bit ADAT Bridge I/O™)

for expanded input and output options, using

their original cables.

When the Legacy Port has been activated from

within Pro Tools, your MIX-series I/O will ap-

pear as channels 17–32 in the Pro Tools mixer.

For more information on using Expansion

or Legacy audio interfaces, see the HD Setup

Guide and the Expanded Systems Guide.

Legacy and Expansion Peripheral Port

Limitations

Because both the Legacy Port and the Expansion

Port use channels 17–32, you can only use one

at a time. The Legacy port is not available in any

session in which the sample rate is set higher

than 48 kHz.

Accessory Port

This port is not supported.

AC Power

This connector accepts a standard AC power ca-

ble (one is included with each audio interface).

The 96 I/O is auto power-selecting (100V to

240V) and will automatically work with a stan-

dard modular cable to connect to AC power re-

ceptacles in any country.

Chapter 2: 96 I/O Hardware Overview