Axxess OESWC-LAN29-STK Kurulum Talimatları - Sayfa 4

Otomobil Parçaları Axxess OESWC-LAN29-STK için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Axxess OESWC-LAN29-STK 8 sayfaları. Axxess interface automobile parts user manual

Sayfayı Yazdır

Wiring Of ASWCSTALK And Interface

1. Connect the BLACK wires of the ASWCSTALK and the BLACK wire

of the interface to ground. You may use the same ground point that is

used for the radio.

2. Connect the GREEN/ORANGE and BLACK/GREEN wires of the

ASWCSTALK to the corresponding wires on the interface.

3. Connect the RED wire to 12 volt accessory

4. Tap off all other unused wires on the interface.

Programming the ASWCSTALK

* If this is the first time the ASWCSTALK is being installed:

1. Turn the ignition on; the led will start flashing rapidly which means the

interface is looking for the ASWCSTALK and the radio. Go to step 3.

* If the ASWCSTALK was installed before:

1. Turn the ignition on, the led will flash slowly

2. Hold down the reset button for more then 2 seconds but less then 10

seconds, the led will start flashing rapidly

3. The ASWCSTALK INTERFACE will automatically find the

ASWCSTALK and radio.

4. After a couple of seconds the led should stop flashing and not light up

for 2 seconds. At this point do not push any buttons.

5. After the 2 seconds there will be a series of 7 flashes, some short and

some long.

6. The led will pause for another 2 seconds then flash up to 10 times.

7. This is the end of the auto detection stage. If the ASWCSTALK

interface detected the vehicle and the radio successfully the led will

light up solid red.