Epson 890N - FX B/W Dot-matrix Printer Ürün Bilgi Kılavuzu - Sayfa 11

Yazıcı Epson 890N - FX B/W Dot-matrix Printer için çevrimiçi göz atın veya pdf Ürün Bilgi Kılavuzu indirin. Epson 890N - FX B/W Dot-matrix Printer 19 sayfaları. Impact printers
Ayrıca Epson 890N - FX B/W Dot-matrix Printer için: Kullanıcı Kılavuzu (48 sayfalar), Manuel (11 sayfalar), Teknik Özellikler (2 sayfalar), Teknik Özet (7 sayfalar)

Sayfayı Yazdır

Epson 890N - FX B/W Dot-matrix Printer Ürün Bilgi Kılavuzu

EPSON FX-890/FX-2190

Setting the Paper Release Lever

Set the paper release lever to indicate the paper source you want

to use, as described in the table below.

Lever position

Description

Single-sheet position

For loading single-sheet paper from the top or front

slot.

Front push tractor position

For loading continuous paper with the tractor

installed in the front push position or when using

the front push and pull tractors in combination.

Rear push tractor position

For loading continuous paper with the tractor

installed in the rear push position or when using

the rear push and pull tractors in combination.

Pull tractor position

For loading continuous paper from the tractor

installed on top of the printer in the pull position.

You can load paper in the front, rear, or bottom

slot.

10 - EPSON FX-890/FX-2190

Adjusting the Paper-Thickness Setting

First turn off the printer and open the printer cover. Then set

the paper-thickness setting for the type of paper you are using.

(See the table below.)

Paper type

Ordinary paper

Thin paper

Carbonless multipart forms with:

2 parts (original + 1 copy)

3 parts (original + 2 copies)

4 parts (original + 3 copies)

5 parts (original + 4 copies)

6 parts (original + 5 copies)

7 parts (original + 6 copies) *

Continuous paper with labels

Postcards

Envelopes

* Available when using the tractor in the bottom or front pull position.

Note: When the temperature is 41°F (5°C) or lower, or 95°F (35°C) or

higher, set the paper-thickness lever one position lower to improve

print quality. Multipart forms with 7 parts cannot be used at these

temperatures.

6/03

Lever position

0 or 1 (single sheets)

0 (continuous paper)

5 or 6