Epson ActionLaser 1400 Kullanıcı Kılavuzu - Sayfa 4
Yazıcı Epson ActionLaser 1400 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Epson ActionLaser 1400 8 sayfaları. Flatbed inkjet printer
Ayrıca Epson ActionLaser 1400 için: Önce Bu Kılavuzu Okuyun (27 sayfalar), Kullanıcı Kılavuzu (30 sayfalar)
Sayfayı Yazdır
EPSON ActionLaser 1400
The five screens are listed below, along with the items
available on each
Items
Menu
Page Setup
Copies
Lines per Page
Orientation
Paper Feed
Paper Size
Auto Continue
Font
Typeface
Point/Pitch
Symbol Set
Toner Saving
Quality
Edge Smoothing
Resolution
Toner Density
Memory
Page Protection
Power Save Mode
Options
Power Save Interval
Status and Error Messages
Status, error, and caution messages appear on screen to
notify you of the printer status and alert you to problems.
Error messages tell you how to correct any problems that
occur.
Front Panel Lights
The two lights on the front panel allow you to monitor the
status of the printer. The green Ready light is on when the
printer is on and is ready to receive print data. As data is
received from the computer, the Ready light flashes.
The orange Error light indicates an error condition. If the
Error light is on continuously, it indicates that no paper is
loaded or that there is a paper feed jam. A flashing Error light
indicates one of the following: an internal paper jam has
occurred, the front cover is open, or the toner cartridge is not
installed.
Other status conditions are indicated by the combination of
the Ready and Error lights. The following table describes all
status conditions that can be indicated by the printer's
Ready and Error lights:
AL1400-4
Ready
Error
Off
Off
Slow
Off
flashing
Flashing
Off
On
Off
Off
On
Off
Flashing
Flashing
On
Flashing
Flashing
I
On
On
Loading Paper
To load a stack of paper in the printer's paper tray:
1. Remove any paper remaining in the paper tray. Do not add
paper to a partial stack.
2. Pull the paper release lever toward the front of the printer.
3. Fan a stack of paper and load the paper in the paper tray.
Place the paper side you want printed face down in the
paper tray. Up to 100 sheets can fit in the paper tray.
4. Slide the paper guides against the paper stack so the paper
fits loosely between them. The paper guides should not fit
too tightly against the paper.
5. Push the paper release lever toward the back of the printer.
This places the feed roll in contact with the paper stack.
Paper will not feed properly if the paper release lever is
not in the feed position.
10/15/94
Printer status
Printer is off.
Printer is in power save mode.
Print data is being received at the printer or
has already been received.
Printer is ready to receive print data.
Either the paper tray is empty or there is a
paper feed problem.
One of the following errors has occurred:
One of the following errors has occurred:
waiting for the next sheet.
The printer is warming up.
I
A printer engine or controller error has
occurred. Contact your dealer or a qualified
service person.
Laser Printers