Digidim 503AV Kullanıcı Kılavuzu - Sayfa 4

Kayıt Ekipmanları Digidim 503AV için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Digidim 503AV 16 sayfaları. Av interface package

Digidim 503AV / 505 RS232 AV Interface User Guide

2. Interface Power

2.1. 505 Interface Power

The Digidim 505 interface takes power from the serial port for operation of the RS232 link.

This differs between the old type (black case) and new type (transparent case).

Either or both the RTS and DTR lines must be set to HIGH for operation. Internally the

lines are diode 'or'd'.

Note:

Some low-power RS232 ports do not provide enough power if only one of these

lines is HIGH. Setting both to HIGH always provides enough power

This requires the RTS line to be set to HIGH, and the DTR line to be set to LOW. Both

these lines must be connected for the interface to function. No ground connection is

required.

Note:

Internally, the DTR line is connected to DCD, but connection to DCD is not

required for operation.

Where the control interface does not allow setting of the RTS and DTR lines as required

then an external DC supply must be used. The exact specification of the DC supply is not

critical but must be of double-insulation rating with a floating output. The voltage must be

between +/- 4 and +/- 12 volts and remain stable with no load. The supply negative is

connected to pin 4 of the interface, the supply positive to pin 7 of the interface, and the

supply 0 volt reference to the Host GND connection.

The main operating power and DALI communications are taken from the DALI connection.

In the absence of a DALI supply connection the interface will not function.

Note:

Interface's nominal power consumption is 3mA from the RS232 port and 10mA

from DALI.

The interface is powered entirely from the Digidim connection. The RS232 connection is

RX, TX and GND. All connections are via terminals, with the Digidim connection using the

standard Helvar 6-way terminal connector.

Doc. No. 7860076

Page 2

Helvar Ltd.

Issue 8