Arcflash Labs EMG-01 Alpha Kullanıcı Kılavuzu - Sayfa 8
Elektrikli Alet Arcflash Labs EMG-01 Alpha için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Arcflash Labs EMG-01 Alpha 16 sayfaları. 8 stage igbt coilgun
Sayfayı Yazdır
The trigger of the EMG-01A is connected to a small microswitch internally and is
actuated by a small spring. The trigger only has roughly 0.25" of travel length and the spring
return is very fragile. If excessive pressure is exerted on the trigger, the spring return could
detach. If this occurs, discontinue use of the gun and immediately return to the manufacturer
for repairs. If further pressure is exerted on the trigger, damage to the microswitch could
result.
2.7 Magazine
- Always pull back the release lever before inserting a magazine. "Slamming" a magazine
into the gun without depressing the release lever will damage the retaining mechanism
and will shorten the lifespan of the gun.
The EMG-01A uses a proprietary magazine design which was designed to accommodate
a 9-round 3D-printed conformal magazine (the MG9-CS). The magazine uses a steel coil spring
to store up to 9 0.25x0.75" projectiles. However, the injector solenoid on the EMG-01A is only
capable of firing 6 out of the 9 rounds fully auto. This is due to the high spring pressure in the
magazine and the limitations of captive solenoid injectors.
An upgraded 20-round magazine and an upgraded high force injector are currently in
development and at least one of the two components should be available by the time the EMG-
01B is released.
2.8 Capacitors
- The EMG-01A contains two large 180mF capacitors capable of storing up to 100J of
combined energy.
The EMG-01A contains two very large electrolytic capacitors (360,000 uF total
capacitance) – at the time of construction these are the highest density electrolytic capacitors
in production. They are capable of delivering up to 300A burst current at 25V and storing over
100J of energy.
The capacitors remain charged for approximately ONE MINUTE after disconnecting all
power from the gun. During this time, the gun will still be fully functional and pressing the
trigger will still fire a round. To power down the gun we recommend the following procedure:
1) set the microcontroller to "SAFE", 2) remove the Main Fuse from its socket – this
immediately removes the battery from the circuit, 3) remove the magazine from the gun, verify
that there is no round still remaining in the barrel, and 4) wait for ALL LEDs (especially the blue
LED near the handle) to extinguish before removing the battery.
The blue LED near the handle indicates the state of charge on the capacitors. If the blue
LED is active, the capacitors are charged.
8 |
P a g e