Arch PS 5000 Operatör El Kitabı - Sayfa 6
Su Filtrasyon Sistemleri Arch PS 5000 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Arch PS 5000 16 sayfaları.
After completing the PRE-START-UP CHECKLIST, and establishing that all components of the chlorinator are
operating properly, your PULSAR® 3 Chlorinator is ready for start-up. Routine maintenance of the PULSAR®
3 Chlorinator is minimized when proper pool water balance is maintained. Maintain pool water chemistry as
follows:
Total Alkalinity
Calcium Hardness
pH
Adherence to these recommendations at all times will ensure the most eff ective and economical performance from
the PULSAR® 3 Chlorinator.
NOTE: Th e use of CO2 to lower pH will raise Total Alkalinity. High total alkalinity (over 80 ppm) will increase
scale and solids buildup in chlorinator.
WARNING: Use ONLY Pulsar® Plus Briquettes in the Chlorinator. Th e use of any other treatment chemicals
will void the warranty. DANGER: Under no circumstances mix calcium hypochlorite with other forms of
concentrated chlorine or other chemicals. Fire and/or explosion may result. Caution must be used when refi lling
dispenser.
KEEP OUT OF REACH OF CHILDREN
1. Fill the Briquette Tank with Pulsar® Plus Briquettes. Th e Briquette Tank holds 62 pounds of briquettes.
2. Check the chart below to determine an approximate start-up timer setting for your pool (or be certain that
the ORP Controller is calibrated and the set-points are correct). Set the Upper and Lower Timer Knobs at the
recommended setting.
NOTE: For best chlorinator performance, use the "normal" bottom timer setting. Th is will assist in maintaining desired
Free Available Chlorine level in pool and help maintain chlorinator maintenance.
3. Open all valves to the pool and to the chlorinator.
4. Monitor the water fl ow to the chlorinator daily to ensure that a proper fl ow is being maintained.
5. During the fi rst few days of operation, check chlorine level in the pool frequently to establish the best Timer
setting (or ORP Controller setting) for your pool. Adjust the chlorine output either up or down according to
the table or, adjust the ORP setpoint.
High Bottom Timer Setting
Unstabilized
Stabilized*
492
86
30
18
12
—
—
Start-Up Procedures
60-80ppm
200-1800ppm
7.2-7.6
Recommended Start-Up Settings
Pool Size in thousands of gallons (000)
Low Bottom Timer Setting
Unstabilized
1,800
370
440
67
116
24
60
12
43
—
37
—
30
—
* Do not exceed 25 ppm stabilizer
Stabilized*
1,353
350
98
43
37
30
25
– 3 –
Normal Bottom Timer Setting
Unstabilized
Stabilized*
220
836
37
197
12
50
—
25
—
20
—
17
—
12