Arch Pulsar 3 series Operatör El Kitabı - Sayfa 6

Su Filtrasyon Sistemleri Arch Pulsar 3 series için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Arch Pulsar 3 series 16 sayfaları.

Sayfayı Yazdır

After completing the PRE-START-UP CHECKLIST, and establishing that all components of the chlorinator are

operating properly, your PULSAR® 3 Chlorinator is ready for start-up. Routine maintenance of the PULSAR®

3 Chlorinator is minimized when proper pool water balance is maintained. Maintain pool water chemistry as

follows:

Total Alkalinity

Calcium Hardness

Adherence to these recommendations at all times will ensure the most eﬀ ective and economical performance from

the PULSAR® 3 Chlorinator.

NOTE: Th e use of CO2 to lower pH will raise Total Alkalinity. High total alkalinity (over 80 ppm) will increase

scale and solids buildup in chlorinator.

WARNING: Use ONLY Pulsar® Plus Briquettes in the Chlorinator. Th e use of any other treatment chemicals

will void the warranty. DANGER: Under no circumstances mix calcium hypochlorite with other forms of

concentrated chlorine or other chemicals. Fire and/or explosion may result. Caution must be used when reﬁ lling

dispenser.

KEEP OUT OF REACH OF CHILDREN

1. Fill the Briquette Tank with Pulsar® Plus Briquettes. Th e Briquette Tank holds 62 pounds of briquettes.

2. Check the chart below to determine an approximate start-up timer setting for your pool (or be certain that

the ORP Controller is calibrated and the set-points are correct). Set the Upper and Lower Timer Knobs at the

recommended setting.

NOTE: For best chlorinator performance, use the "normal" bottom timer setting. Th is will assist in maintaining desired

Free Available Chlorine level in pool and help maintain chlorinator maintenance.

3. Open all valves to the pool and to the chlorinator.

4. Monitor the water ﬂ ow to the chlorinator daily to ensure that a proper ﬂ ow is being maintained.

5. During the ﬁ rst few days of operation, check chlorine level in the pool frequently to establish the best Timer

setting (or ORP Controller setting) for your pool. Adjust the chlorine output either up or down according to

the table or, adjust the ORP setpoint.

High Bottom Timer Setting

Unstabilized

Stabilized*

492

—

Start-Up Procedures

60-80ppm

200-1800ppm

7.2-7.6

Recommended Start-Up Settings

Pool Size in thousands of gallons (000)

Low Bottom Timer Setting

Unstabilized

1,800

370

440

116

—

* Do not exceed 25 ppm stabilizer

Stabilized*

1,353

350

– 3 –

Normal Bottom Timer Setting

Unstabilized

Stabilized*

220

836

197

—