Archery Arch Well 1m Butt Talimatlar - Sayfa 2

Raflar ve Standlar Archery Arch Well 1m Butt için çevrimiçi göz atın veya pdf Talimatlar indirin. Archery Arch Well 1m Butt 2 sayfaları. Target stand

Construction:

1. Measure the actual width of your target

2. Cut the top and bottom beam to 5mm shorter than actual target width

3. Drill a hole in the center of the bottom beam to attach the rope through later

4. Center top and bottom beam on top and bottom of target

5. Fix with ratchet straps and pull tight to squeeze in target from top and bottom

7. Screw on front legs on each side, make sure there are no gaps – another set of ratchet straps can be

helpful. As the top and bottom beams are 5mm shorter than the target width this squeezes the target

between the legs.

8. Measure 300mm from the top on front leg and mark it. Line up marking with rear leg and screw one

screw 40mm from top into the exact centre.

9. Repeat on other side.

10. Clamp rear legs to front legs in preparation to screw on rear cross beam

11.

12. Screw on rear crossbeam

13. Drill a hole into the centre of crossbeam

14. Open target legs and stand up on ground to an angle of your liking. Feed rope through both holes and tie

a thick knot on each side to stop target from opening further.

Done