Epson DFX-5000+ Ürün Destek Bülteni - Sayfa 3

Yazıcı Epson DFX-5000+ için çevrimiçi göz atın veya pdf Ürün Destek Bülteni indirin. Epson DFX-5000+ 8 sayfaları. Product support bulletin(s)
Ayrıca Epson DFX-5000+ için: Broşür ve Teknik Özellikler (24 sayfalar), Ürün Destek Bülteni (20 sayfalar), Ürün Destek Bülteni (3 sayfalar), Ürün Bilgileri (5 sayfalar), Ürün Destek Bülteni (5 sayfalar), Ürün Destek Bülteni (3 sayfalar), Manuel (8 sayfalar), Ürün Destek Bülteni (20 sayfalar), Ürün Destek Bülteni (14 sayfalar), Ürün Destek Bülteni (25 sayfalar), Ürün Destek Bülteni (16 sayfalar), Ürün Destek Bülteni (2 sayfalar)

Sayfayı Yazdır
Epson DFX-5000+ Ürün Destek Bülteni
EPSON
EPSON AMERICA, INC.
Subject:
Tractor
Date: 5/15/89
Page: 1 of 1
The purpose of this bulletin is to insure the proper installation and alignment of
the FX-850/1050 and LQ- 850/1050 push tractor assemblies.
There are two possible ways to install the tractor frame on the push tractor
assembly. If the frame is installed incorrectly, the tractor belt pins on the two
tractors will not be aligned, and the resulting printout appears to be slanted on
the page, or the perforated edge will be tom. This is caused by the marks on
the tractor shaft holders being 180 degrees 'out of phase.'
When assembling a tractor, there are two grooves in the shaft, and two tabs
on
tractor
the
shaft holder.
will be necessary to disassemble the tractor, and rotate one tractor shaft
bring it back into alignment with the other shaft holder.
180 degrees, to
Alignment can be verified by examining the marks in
will both be in the forward position when properly aligned, as shown in
4-
51 below.
INFORMA
Product Support Bulletin
Pin Alignment
lf the pins on both tractor belts are not aligned, it
Figure 4-51. Tractor Assembly
0044
PSB No: P -
Originator: RP bd
the shaft holders, which
Phases
holder
Figure