Aydin Displays VFP20 series Kullanıcı Kılavuzu - Sayfa 7

Düz Panel TV Aydin Displays VFP20 series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aydin Displays VFP20 series 17 sayfaları. 20" flat panel display

Sayfayı Yazdır

DISPLAY CONNECTIONS AND ADJUSTMENTS:

If you have any problems connecting, setting up, or operating the display, please refer to the

Troubleshooting section of this guide.

VIDEO INPUT 1 - DVI-I Connector:

For Analog Video input, connect the DVI-A connector of the video cable to the DVI-I connector on the

rear of the display and the other end to the HD15 connector on the computer.

For Digital Video input, connect one end of the DVI-D Digital video cable to the DVI-I connector on

the rear of the display and the other end to the DVI connector on the computer.

VIDEO INPUT 2 - DVI-D Connector and HD15 Connector:

For Analog Video input, connect one end of a VGA video cable (not supplied) to the HD15 connector

on the rear of the display and the other end to the HD15 connector on the computer.

For Digital Video input, connect one end of the DVI-D Digital video cable to the DVI-D connector on

the rear of the display and the other end to the DVI connector on the computer.

If a Touch Screen option has been provided, connect the interface cable from the touch interface

connector on the rear of the display to the proper RS232 Serial Controller.

Plug the power cord into the rear of the display and then plug the cord into an AC power source. Turn

on the display. The Green ON LED should light. If the Amber NO SYNC LED is lit, refer to the

Troubleshooting section.

CONTROLS:

On-Screen-Menu (OSM) Controls:

The OSM controls on the front of the monitor function as follows:

To access OSM menu, press any of the control buttons (LEFT, RIGHT, UP, DOWN)

To change signal input, press the "SELECT" button when OSM is NOT selected.

Control

EXIT

LEFT, RIGHT

DOWN, UP

SELECT

RESET

Note: When "RESET" is pressed in the main or sub-menu, a warning window will appear allowing you to cancel the reset function

by pressing the EXIT button.

150-VF20-001(A).doc

Main Menu

Exits the OSM menu.

Moves the highlighted area left/right to

select desired sub-menus.

Moves the bar left/right to increase or decrease

the selected adjustment.

Active Auto Adjust function. Enter the OSM control.

Resets the highlighted control menu to the factory

setting.

Sub-Menu

Exits to the OSM sub-menu

Moves the highlighted area left/right

to select one of the functions.

Moves the bar left/right to increase

or decrease the selected adjustment.

Enter the OSM Sub menu.