CREE LIGHTING Cadiant Experience Dynamic Skylight Kurulum Talimatları - Sayfa 3

Işık Fikstürü CREE LIGHTING Cadiant Experience Dynamic Skylight için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. CREE LIGHTING Cadiant Experience Dynamic Skylight 3 sayfaları.

Sayfayı Yazdır

RESET RF MODULE

NOTE: The Blue LED is located behind the CREE logo on the RF Module.

The CREE logo will illuminate blue when the Blue LED is active.

STEP 1:

Actuate RESET button through the access hole. Push and hold until LED

on RF module begins blinking rapidly (approximately 6-7 seconds). See

Figure 2.

STEP 2:

Release for 1 sec.

STEP 3:

Press/Hold RESET button for 0.5 sec. Light will turn off for a few

seconds then go to full bright and the Blue LED on the RF Module

should begin a 2 blink sequence. Figure 2.

TROUBLESHOOTING:

Out of the box, if the light does not turn on when power is applied:

•

Check Wiring with power off

•

If wired correctly, check to see if Blue LED blinking on the RF

Module.

•

If Blue LED is blinking, then perform a RESET

(See RESET RF MODULE section).

•

If Blue LED is on solid or off, call Cree Customer Service.

•

If you have done a RESET, and the light is still off, call Cree

Customer Service.

If light is unresponsive, use Cree Configuration Tool to verify

configuration.

ELECTRICAL CONNECTIONS

STEP 1:

Make the following Electrical Connections:

a. Check the voltage rating on the luminaire label and verify the

voltage from the supply source matches the luminaire voltage

rating.

b. For 120/277V connect the black luminaire lead to the voltage

supply lead (Hot 1 for 208/240V wiring).

c. For 120/277V connect the white luminaire lead to the neutral

supply lead or (Hot 2 for 208/240V wiring).

d. Connect the luminaire green or green/yellow ground lead to the

green supply lead.

subject to change. See http://creelighting.com/warranty for warranty and specifications. Cadiant

Lighting, A company of IDEAL INDUSTRIES. Cree

registered trademark of the National Electrical Manufacturers Association.

3 of 3

and the Cree logo are registered trademarks of Cree, Inc. NEMA

FCC NOTICE

To comply with the FCC RF exposure compliance requirements,

this device and its antenna must not be co-located or operating to

conjunction with any other antenna or transmitter.

This equipment should be installed and operated with minimum

distance 5cm between the radiator & your body.

FCC COMPLIANCE STATEMENT

CAUTION: Changes or modifications not expressly approved could void

your authority to use this equipment.

This device complies with Part 15 of the FCC Rules. Operation to

the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation

This device has been tested and found to comply with the limits for

a Class A digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the device is operated in a commercial environment.

This device generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instruction manual,

may cause harmful interference to radio communications. Operation of

this device in a residential area is likely to cause harmful interference

in which case the user will be required to correct the interference at his

own expense.

The LED in the front of this device operates within Risk Group 1 levels

per IEC 62471.

INDUSTRY CANADA STATEMENT

This device complies with Industry Canada licence-exempt RSS

standard(s). Operation is subject to the following two conditions: (1) this

device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation

of the device. In addition, this device complies with ICES-003 of the

Industry Canada (IC) Regulations.

Le présent appareil est conforme aux CNR d'Industrie Canada

applicables aux appareils radio exempts de licence. L'exploitation est

autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas

produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout

brouillage radioélectrique subi, même si le brouillage est susceptible

d'en compromettre le fonctionnement.

LINE

OR HOT 1

GREEN

NEUTRAL

OR HOT 2

is a trademark of Cree

™

is a

JUNCTION

LUMINAIRE

BOX

LINE-BLACK

GROUND-GREEN

NEUTRAL-WHITE

www.creelighting.com

LPN00647X0001A0_D