Digiflex CM430S Yükleyici Referans Kılavuzu - Sayfa 7

Medya Dönüştürücü Digiflex CM430S için çevrimiçi göz atın veya pdf Yükleyici Referans Kılavuzu indirin. Digiflex CM430S 8 sayfaları. Rs485 lan to ethernet converter module

Sayfayı Yazdır

Windows IP Configuration

Click on Start button and choose Settings.

1. Choose Network & Internet.

2. Click on Ethernet -> Change adapter options. ...

3. Click Internet Protocol Version 4 (TCP/IPv4), and then click Properties. ...

Before changing any of the numbers, ensure you take note of the original settings, as

Digiflex does not take any responsibility for your PC configuration, if you are

CM430S Reset

The CM430S modules can be reset whilst powered up by using a thin screwdriver and sliding the Reset switch from

OFF to ON position, then after 2-3 seconds, back to the OFF position. This will reset the device IP to 192.168.1.254

CM430S Specifications

Part Number:

Operating Voltage:

Module Connection:

(RS485 LAN)

Operating

Environment:

Certification:

Warranty:

this will disconnect you from your normal network connection.

not experienced in networking, please contact your IT person.

Figure 7: Windows PC IP Config Setup Page

CM430S - RS485 LAN To Ethernet Module - Supporting Star Configuration

10.5V D.C - 14.5V D.C. @ 150mA Max

Ethernet Interface: 10 / 100Base-T, Half / Full Duplex

RS485 Signal: 2 wire Data+/-

0˚ to 55˚C RH 5 to 80% at 30˚C non-condensing.

EN55032:2012, EN55024: 2010.A1:2015,

EN61000-3-2:2014, EN61000-2-2:2013

3 years from date of manufacture (return to base).

In the interest of ongoing product development this

document is subject to change without notice.

E&OE

Warning:

P/N: CM430SIRG Rev 1.2

Page

