Digiflex PC100 Kurulum Kılavuzu - Sayfa 2

Muhafaza Digiflex PC100 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Digiflex PC100 2 sayfaları. Plastic housing

Introduction

The PC100 Plastic Housing can be use to locate an expansion module in a remote area

of the building and is especially useful when the module does not require a seperate

power supply and battery. The PC100 includes a tamper switch that can be connected

to the module tamper input. When installed correctly, the housing provides front and

rear tamper protection. The PC100 can also be attached to the lid of the main panel

to provide an additional module space without needing to add an additional metal

cabinet.

1) Opening The Housing

Insert a 2.5mm flat blade screwdriver into the

cam lock and turn anti clockwise for a 1/4 turn.

Then lift the lid clear of the rear housing.

2) Mounting The Housing

The PC100 includes a number of mounting holes

and cable entry knockouts to suit almost any

mounting requirement. Make sure to install the

screw for the rear tamper protection to work. See

Figure 2.

3) Mounting the Module

Using the supplied phillips head screws, mount the module to the housing and fit the

supplied tamper lead to the module's tamper input. When finished replace the PC100

lid and turn the cam lock clockwise to secure.

Connect tamper cable to the

supplied tamper connection

on your PCB

P/N: PC100IRG Rev 1.0

Turn anti clockwise to unlock

Figure 1: Cam Lock

4) Rear Housing Showing Mounting Holes

Mounting Holes

C Rear Tamper Screw

Figure 2: Rear Housing Layout

E&OE

Module Mounting

Supports

Cable Knockouts