Ayite GE-103P Kullanıcı Kılavuzu - Sayfa 5

Sonar Ayite GE-103P için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Ayite GE-103P 6 sayfaları. Portable echo sounder ultrasonic depth meter

Sayfayı Yazdır
* Serial communication protocol
[Standard Baud Rate]
The system uses the asynchronous half-duplex communication, the baud rate could be
600~19200bps.
1. Master Meter: sent the address (1-64), then receive the data
2. Slave meter: Answer the master meter by stop, each frame sent 21 BYTE
The first 5 BYTE is water depth (5 BYTE ASC code, the unit is meter)
the BYTE 6~20 just for test in produce, no need pay attention
st
21
BYTE is Checksums
e.g. the below is a data sent by the meter
30 2E 35 30 31 31 31 33 2E 37 36 31 41 5C 2D 86 3F 00 4D B5 E6
----- water depth = 0.501m（30 2E 35 30 31） ；
----- 6~20 just for test in produce；
----- E6 is Checksums
* Troubles
Matter
Press the key for Power
On, no display; the sensor
don't have sound
The sensor have sound,
but the meter don't
display
Meter display, but the
value will not change
when sensor move, the
sensor don't have sound
Meter display, sensor
sound, but the value
change quickly, or the
value will not change,
when the depth is change
Sensor Sound, but the
meter dsplay"- - - -"
http://www.ayite1973.com
A.YITE INSTRUMENT CORP
Reason
1. No power, need charge; 2.
the Li-baterry is destroyed
1. The meter is energy saving
now; 2. the screen is
destroyed
1. The voltage is too low, 2.
sensor is destroyed
1. depth meter installed too
skewed, reflecting not good;
2. Transmitting Power is very
big 3.used in the air
environment; 4.
electromagnetic interference;
1. The measure range is more
than 100m; 2. The water have
so much solid, the sound
could not back; 3.
Http://www.ayite.net
Deal With
1. Charge the Li-baterry; 2. change
the battery, contact with us, don't
change the baterry by yourself
1. Press the move key to open the
display;2. conatct with us
1.supply the voltage as demand
2. conatc with us
1. adjusted the sensor surface
perpendicular to the axis 2.if less
than 20m, power P is about 10,;
more than 30m 10 to 15; 3. put
the sensor into the water; 4.
interference shielding
1. Measure suitable depth, less
than rating; 2. Measure suitable
water; 3. set suitable Transmitting
Power P
Tel/Fax: 852-30205702