Creek Audio 4040 A Kullanım Kılavuzu - Sayfa 9

Amplifikatör Creek Audio 4040 A için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Creek Audio 4040 A 13 sayfaları.

Sayfayı Yazdır

Rotate the right-hand Volume control knob to adjust the volume in 1dB (1 decibel) steps from 0 to 70, maximum.

It is important to note that the power output of the amplifier is the product of both the volume setting and the

input signal level from the source equipment. Sources with lower output signals will require the amplifier's volume

setting to be higher to achieve the required loudness. Don't worry if you find the volume is approaching maximum

(70) to achieve your preferred listening level, it does not necessarily mean the amplifier is working too hard.

The volume setting is stored when the amplifier is powered – OFF, but when the 4040 A is powered – ON again the

last setting will be restored, unless the level was higher than 40. So, if the amplifier's volume is set between 41 and

70 and then powered – OFF, when it is powered – ON again, the level will be reduced to 40.

Power ON

Auto Standby

Input

SETUP MENU

Input

Balance

BT Pairing

PA Direct

Dimmer

Brightness

Auto Standby

USB Wake On

Info

Reset

RIGHT-HAND CONTROL KNOB FUNCTIONS

LEFT-HAND KNOB FUNCTIONS

Press once to manually power-ON from Standby mode.

Press for 2 seconds to manually enter Standby mode.

Rotate to select three analogue and four digital inputs.

Press once to enter and rotate to access the following options.

Press and select a new input.

Rotate left or right to move the stereo image between speakers.

Select ON to enable EQ (Tone controls). Select OFF to disable EQ.

Treble and bass can only be adjusted when EQ is ON.

Treble Boost or cut treble as required.

Bass

Boost or cut bass as required.

Select Bluetooth Input first. Go to Settings on your mobile device and select Creek Audio

4040A.

Select ON to enable PA Direct mode. Select OFF to return to Line 1.

WARNING Do not connect a source device to PA Direct without a pre-amp in front to control

the volume level.

Display - Always ON or Auto OFF will turn display off after 20 seconds.

Adjust display brightness.

Adjust to be Always On, Idle 30 mins, Idle 60 mins, or Idle 120 mins.

Select Enabled to wake-up the 4040 A from Standby mode automatically when connected to

a computer or laptop that automatically goes to sleep.

Note Power management may need adjustment in BIOS on a PC or laptop to enable this

function. Go to settings for Apple IOS.

Press to show model number 4040 A and software revision.

Press to return the amplifier to factory default settings.

Page: