Creek Audio EVO Kullanım Talimatları

Amplifikatör Creek Audio EVO için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Creek Audio EVO 2 sayfaları. Creek audio integrated amplifier operating instructions

Sayfayı Yazdır
CREEK EVO INTEGRATED AMPLIFIER SPECIFICATION
POWER OUTPUT (both channels into 8Ω)
POWER OUTPUT (one channel into 8Ω)
POWER OUTPUT (one channel into 4Ω)
PEAK OUTPUT CURRENT INTO 1Ω
TOTAL HARMONIC DISTORTION
(20 Hz to 20 kHz)
FREQUENCY RESPONSE
SLEW RATE
GAIN
INPUT SENSITIVITY - One channel driven/8Ω
PRE-AMP OUTPUT LEVEL
SIGNAL TO NOISE RATIO ('A' weighted)
SEPARATION (line inputs)
MM PHONO SENSITIVITY & IMPEDANCE
MC PHONO SENSITIVITY & IMPEDANCE
POWER CONSUMPTION (at idle)
POWER CONSUMPTION (full power 10% THD)
WEIGHT (net)
SIZE (W x H x D)
MAINS VOLTAGE
@ 60Hz
@ 50Hz
REMOTE HANDSET
MAINS VOLTAGE SELECTOR SWITH ON REAR PANEL
Creek Audio Ltd reserves the right to change or modify the specification of its products without prior warning.
If within two years of puchase date your Creek EVO proves to be defective for any reason other than
accident, misuse, neglect, unauthorized modifcation, or fair wear and tear, Creek Audio Ltd. will, at its
discretion, replace the faulty parts without charge for labour or return carriage within the U.K. This
warranty is valid only in the U.K. and given in addition to statutory rights. Service enquiries outside the
U.K. should be addressed first to the supplying dealer and/or the Creek distributor/importer. Warranties
granted in these countries are entirely at the discretion of the distributor.
Creek Audio Ltd
12 Avebury Court, Mark Road, Hemel Hempstead HP2 7TA, England
Tel:
+44 (0) 1442 260146
85 Watts
100 Watts
170 Watts
> 10 Amps RMS
< 0.1%
5 Hz to 50 kHz - 1 dB
µ
> 25 V per
S
x 68
415 mV line input
Follows input signal level via volume control
X 2
> 96 dB
> 60 dB at 1 kHz
3.5 mV 47 kΩ (when fitted)
0.75 mV 1 kΩ (when fitted)
40 W
340 W
8.6 kgs
19 lbs
430 x 80 x 340 mm 17" x 3.2" x 15.5"
110/120V North America
220/240V Europe, Asia and UK
EVO Supplied (Uses NEC codes)
Fax:
+44 (0) 1442 243766
Internet: www.creekaudio.com
Designed and engineered
in the United Kingdom
OPERATING
INSTRUCTIONS
Thank you for purchasing the Creek EVO. You are now in possession of a State of the Art integrated
amplifier. The functions and operation of the EVO are very simple. However, the following notes are
provided to explain all aspects of its design and use.
MAINS CONNECTION
When unpacking the amplifier please keep the packing material in a safe place for possible future use.
In the pack there is a separate mains cable suitable for connecting to the mains supply in the country
of use. The IEC socket end of the cable should be firmly inserted into the connector on the rear panel
marked "Mains Input".
Before switching on the amplifier check the voltage selector switch on the rear panel to ensure it is set
correctly to the voltage of the country in which the amplifier is being used.
Remember, do not overload the mains wall socket with too many plugs or adaptors. The high quality
performance of the amplifier will be impaired if the electrical supply to it is in poor condition. If in doubt,
consult a qualified electrician or your dealer.
The 'Mains Input' connection is also fitted with a fuse. The value is clearly stated on the rear panel.
INPUT CONNECTION AND SWITCHING
The rotary selector switch on the left-hand side of the amplifier is used to select and listen to any of the
desired inputs. There are four inputs plus tape which is selected by the button marked tape. The
selected input will appear in the display.
As all the line input levels are the same, it is not absolutely necessary to use the precise inputs as
designated. You may, for example, plug a CD player into the Tuner input and obtain exactly the same
result or performance as the dedicated CD input. However, you need to be aware that the front panel
display will always reflect the input as designated on the rear panel.
For added flexibility, the first input on the EVO can be used either for vinyl disc or auxiliary line. To
connect your turntable, it is necessary to have the optional MM or MC phono plug-in board fitted.
Alternatively Creek Audio produces a separate range of phono pre-amplifers. Ask your dealer for full
details.
A pre-amp output and power amp input are shared by RCA sockets on the rear panel marked preamp.
EVO
Integrated Amplifier