Creek Company ODC SPORT LT OUTDOOR DISCOVERY CRAFT Montaj Talimatları - Sayfa 2

Spor & Kamp; Açık Hava Creek Company ODC SPORT LT OUTDOOR DISCOVERY CRAFT için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. Creek Company ODC SPORT LT OUTDOOR DISCOVERY CRAFT 4 sayfaları.

Sayfayı Yazdır

I. PLASTIC SEAT ASSEMBLY

1. Assemble Seat Back to Seat Bottom using Seat Assembly Pins (see figure 1a).

II. ASSEMBLE FRAME

NOTE: Your Frame Assembles using (8) Snap Pins. Please follow instructions accordingly.

1. Assemble Cargo Deck by sliding Mesh Cargo Deck over Rear Frame Member (see figure 1) and secure using attached Hook and

Loop and Ladder Lock/ Strap Fasteners.

2. Assemble Seat to Seat Support Frame Member using (4) Seat Screws. (See Figure 1a)

3. Assemble Seat Support Frame Member to Left and Right Frame Members using (4) of the Short Pins. (see figure 1)

4. Assemble Cargo Deck to Left and Right Frame Members using (2) Snap Pins (see figure 1).

5. Assemble Foot Bars to Left and Right Frame Members using (2) Snap Pins (see figures 1).

III. PONTOON INFLATION

NOTE: Use double action pump with Boston Valve adapters (Not Included), available from the Creek Company. Or use any

standard double action pump.

1. Inflate each Pontoon. The Valve is located inside the Storage Pocket of each Pontoon.(see figure 3).

Inflate until firm (do not over inflate).

2. Be sure top Valve Cap and Valve Assembly are fully seated.

PONTOON DEFLATION: Unscrew entire Valve Assembly from Pontoon.

IV. ATTACH PONTOONS TO FRAME

NOTE: Always inflate the Pontoons first, before attaching to Frame.

1. Position inflated Pontoons under the Left and Right Frame Members with ODC SPORT LT

outside.The Frame Members fit around the Storage Pockets.

2. Attach Pontoons to Frame as illustrated in figures 3 and 3a. Note: Be sure the Straps are pulled tight through the

Cam-lock Buckles. Frame should be positioned forward or aft on the Pontoons to achieve center of gravity for an even

ride when fully loaded on the water.

V. OAR & OARLOCK ASSEMBLY

1. Loosen the wingnut on the Oarlock and slide the Oarlock onto the handle end of the Oar Shaft.

2. Attach Blade end of Oar to end of Oar Handle.

3. Place Oarlock Shafts into Frame.

4. With the Oarlocks installed on the Frame, the oars should be equally adjusted left and right allowing at least two

thumbs' distance between the Oars, to avoid pinching your thumbs when rowing. With the blades perpendicular to

the water, tighten the wingnuts.

VI. ATTACH STRIPPING APRON TO FRAME

1. Snap front two Straps around the Frame underneath the Oarlocks, and snap the back two straps to the Right and Left

Frame Members just behind the Storage Pockets

ODC SPORT LT

OUTDOOR DISCOVERY CRAFT

ASSEMBLY INSTRUCTIONS

logos oriented to the