Digikeijs DR4088RB Series Kullanım Kılavuzu - Sayfa 8
Kontrol Ünitesi Digikeijs DR4088RB Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Digikeijs DR4088RB Series 14 sayfaları.
Ayrıca Digikeijs DR4088RB Series için: Manuel (8 sayfalar), Manuel (9 sayfalar)
Sayfayı Yazdır
DR4088RB-CS / OPTO
3.2 Programming DR4088RB with further DR4088 at S88(N) connection
It is important that the DR4088RB-xx must receive the module address once so that the DR4018RB-xx knows which module address it starts with. In addition, the
DR4088RB-xx must be informed that it consists of X times 8 feedbacks.
This means:
If another DR4088xx is connected to the S88 connection of the DR4088RB-xx, the number of modules increases from 2 to 4.
If the DR4088RB-xx a second DR4088xx is plugged into the S88 connection, the number of modules increases from 4 to 6, and so on.
etc.
Attention! A maximum of four DR4088xx can be connected to the S88 connection on each string consisting of one DR4088RB-xx. This means that the DR4088RB-xx
is assigned module address 1 and then the number of modules 10 is transferred. This means that a maximum of 80 feedbacks are available on string 1.
If a second line is now set up at the R-Bus® , it starts with module address 11. Here, too, a maximum of 4 additional DR4088xx can be connected to the S88 con-
nection of the DR4088RB-xx. The second step here is to transfer the number of modules 10 to the DR4088RB-xx. A maximum of 80 feedback modules are now also
available on this line.
3.2.1 Programming with the DR5000
1.
Open the DR5000 Tool
2.
Properties Call XN-FB Bus
3.
FB Call Programming Module
4.
Now just follow the instructions in the wizard.
Please refer to the instructions above for programming the number of modules.
Example:
DR4088RB-xx —>
DR4088xx
Modul address 1
Number of modules = 4 (x 8 feedback units)
DR4088RB-xx —>
DR4088xx —> DR4088xx —> DR4088xx —> DR4088xx
Modul address 1
Number of modules = 10 (x 8 feedback)
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
2021-07-06
Important!
When using the LN or RB module, the ext88N IN number of 16
and 8 input modules must be set to 0 on the DR5000. This can be checked if
in the feedback monitor row 1 and row 9 are white with blue and not red!
P 8