Digikeijs DR4050 Manuel - Sayfa 5
Kontrolör Digikeijs DR4050 için çevrimiçi göz atın veya pdf Manuel indirin. Digikeijs DR4050 8 sayfaları. Rgb led controller
Sayfayı Yazdır
DR4050 RGB LED CONTROLLER
De module een adres geven
You can give the DR4050 module an address so it can be controlled with your control unit. This is useful if you want to
control the module according to time.
1.
Connect the DCC signal input to your control unit.
2.
Set your control unit to the desired start address that you want to give the module.
3.
Press the programming switch on the module once. The red LED next to the switch turns on.
4.
Now switch your control unit to the set address.
5.
If the module is connected correctly the LED will turn off when the desired address is switched.
6.
The module has now loaded the programming shown below whereby the first address matches the address swit-
ched on your control unit. All subsequent addresses are automatically raised by 1.
Adress 1 (start adress)
Adress 2
Adress 3
Adress 4
*** Red = deflecting
Download the accompanying program from our website:
www.digikeijs.com
OFF
ON
Night
Red
Green
Red
Green = straight
Day
Evening
Morning
Green
Red
Green
Software description
Comport
Select the correct COM port here.
Preview
An example of the chosen colour combinations.
Scene
Select the desired scene to then adjust the colour of the light.
Minutes
The time for which the selected scene should be on when in
automatic mode.
Reload
Reload the previous settings
Store
Save the changes to the module
Default
Reload the factory settings
Switch 'OUTPUT' at Scene:
Toggle the SWITCH output when starting or ending the scene.
Useful for turning on streetlights when the evening mode
starts, for example.
Transition Time (0.1sec)
The transition time between the different scenes.
http://www.digikeijs.com/dr4050
Automatic OFF
Automatic ON
Red
Green
P 5