Digikeijs DR5000 Hızlı Kılavuz - Sayfa 5

Kayıt Ekipmanları Digikeijs DR5000 için çevrimiçi göz atın veya pdf Hızlı Kılavuz indirin. Digikeijs DR5000 5 sayfaları.
Ayrıca Digikeijs DR5000 için: Hızlı Kılavuz (12 sayfalar)

Sayfayı Yazdır
Digikeijs DR5000 Hızlı Kılavuz
DR5000 DIGICENTRAL
18.02.2019
How can I set the network protocol (Z21, XpressNet, etc.)?
This short manual does not replace the complete DR5000 manual, but only complements the exis+ng documenta+on.
The DR5000 can communicate with various protocols via the LAN/WLAN interface. There are two different setup op-ons for making these seIngs. A connec-
-on to the PC or laptop via USB is always required.
Op'on 1:
Change the network protocol if there is a connec-on to the home network via a router:
1.
Establish USB connec-on with DR5000!
2.
LAN interface of the DR5000 to the home network (router).
The home network router assigns an IP address to the DR5000. This process normally takes about 30 seconds.
3.
Open the DR5000 Tool. (Connec-on type DR5000 Tool must be set to USB)
4.
Open LAN seIngs in DR5000 Tool.
5.
Select the required protocol.
Confirm the selec-on with the green -ck.
6.
7.
It takes approx. 60 seconds un-l the LAN/WLAN module of the DR5000 is restarted.
8.
The DR5000 can now communicate using the selected protocol.
Op'on 2
Change the network protocol via WLAN:
Establish USB connec-on with DR5000!
1.
2.
Now the PC must be connected to the WLAN of the DR5000.
AKer you have found the DR5000's WLAN network in the Windows network dialog click and enter the WLAN
password. (Factory se ng 12345678)
The connec-on will now be established. This process normally takes about 30 seconds..
3.
Open the DR5000 Tool. (Connec-on type DR5000 Tool must be set to USB)
4.
Open LAN seIngs in DR5000 Tool.
5.
Select the required protocol
Confirm the selec-on with the green -ck.
6.
7.
It takes approx. 60 seconds un-l the LAN/WLAN module of the DR5000 is restarted.
8.
The DR5000 can now communicate using the selected protocol.
If the DR5000 is not connected via the Lan interface to the home network (router) or via Wlan to the PC or laptop, the Lan seIngs of the DR5000 are grayed
out and not accessible and therefore cannot be changed! A connec-on via USB to the DR5000 is always required to change the Lan seIng!
www.digikeijs.com
1
2
2
Please pay a0en-on!
3
1
1
2
3
P 5