Digilock ATH Programlama ve Kullanım Talimatları - Sayfa 3
Kilitler Digilock ATH için çevrimiçi göz atın veya pdf Programlama ve Kullanım Talimatları indirin. Digilock ATH 4 sayfaları. Keypad locks advanced security
Sayfayı Yazdır
Auto Unlock and LED Usage Indicator
Locks can be programmed to auto unlock after a set amount of hours and to have the LED flash or not flash while the lock is in use.
The default setting is OFF for Auto Unlock (does not auto unlock) and ON for LED Usage Indicator (flashes while in use).
To turn on Auto Unlock (unlock after a set number of hours):
a.
Press = ` then touch the Manager Bypass Key to the key slot until a two-tone beep is heard and the LED turns on.
b.
Set the amount of hours: Press 1 - 8 A two-tone beep will be heard and the LED will turn off.
c.
Repeat above steps for each lock.
To turn off the LED Usage Indicator:
a.
Press = ` then touch the Manager Bypass Key to the key slot until a two-tone beep is heard and the LED turns on.
b.
Press 0. A two-tone beep will be heard and the LED will turn off.
c.
Repeat above steps for each lock.
To turn off Auto Unlock and turn on LED Usage Indicator (Default Setting):
a.
Press = ` then touch the Manager Bypass Key to the key slot until a two-tone beep is heard and the LED turns on.
b.
Press 9. A two-tone beep will be heard and the LED will turn off.
c.
Repeat above steps for each lock.
Operating Instructions
Operate with any User Code:
To lock: Close the door, then press = _ _ _ _ `
▪
To unlock: Press = _ _ _ _ `, then open the door.*
▪
(the same 4-digit code)
Operate with any User Key:
To lock: Close the door, then touch any User Key to the key slot.
▪
To unlock: Touch the same User Key to the key slot, then open the door.
▪
Operate with a registered Manager Bypass Key**:
To lock: Close the door, then touch a registered Manager Bypass Key to the key slot.
▪
To unlock: Touch a registered Manager Bypass Key to the key slot, then open the door.
▪
Operate with the Programming Key**:
To lock: Close the door, press = `, then touch the Programming Key to the key slot.
▪
To unlock: Press = `, then touch the Programming Key to the key slot.
▪
*The lock will go into "Sleep Mode" after 3 consecutive incorrect entries.
**If a registered Manager Bypass Key or the Programming Key is used to unlock and relock, the previous User Code or User Key will continue to
operate the lock.
Product Guide
Keypad Locks Advanced Security
(amount of hours)
For example: 7 sets the lock to auto unlock after 7 hours.
(any 4-digit code)
Shared Use
ATS, ATV & ATH
Phone: 707 766 6000
www.digilock.com | [email protected]