FIAMA F20 Kullanım Kılavuzu ve Bakım - Sayfa 6
Monitör FIAMA F20 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Bakım indirin. FIAMA F20 8 sayfaları. Display with internal battery power supply and hollow shaft rotative transducer
Ayrıca FIAMA F20 için: Kullanım Kılavuzu ve Bakım (7 sayfalar)
Sayfayı Yazdır
F20
Display for magnetic band
Origin displacement
This parameter is added or subtracted from the current quota to correct the value showed on the display, for
example following wear or changing of tool. Setting a positive value on display appears the current quota added
to this value.
Set zero to exclude the offset function (manufacturer's value).
The offset is not available if the function of tool-change is selected.
Adjusting of quota
Dopo avere montato il sensore sulla macchina ed avere impostato tutti i parametri dello strumento, per
visualizzare sul display la corretta misura occorre effettuare il reset o il preset della quota. Posizionare il
sensore in un punto nel quale sia nota con precisione la corretta misura da visualizzare (es. battuta di
riscontro) oppure misurare la quota in quel punto dell'asse.
Programme parameter
with value 3 in the first digit on the right and go out of the programming. Now
press
and it will appear Preset, press again 2 times
and set on the display the correct measure to
RESET
RESET
visualize, confirm with
and on the display appears the correct measure.
RESET
If the adjusting quota is worth to zero instead of the preset is possible use reset, setting value 1 on the first digit
on the right of
, this way pressing
the value on the display will be zeroed.
RESET
Now that the instrument is adjusted its necessary re-establish to the wanted value parameter
to
avoid
Battery change
The instrument is supplied with batteries type AA of 1,5V (alkaline type) which assures a functioning of about 2
years. When the loading level goes under a certain value, the indicator of flat-battery begins to blink in
occasional way and when it keeps switched on its necessary to change the batteries within a month.
To enter into the battery-holder its necessary to take off the front-cover prising on the two hollows placed on a
side of the instrument. Take off the cover and take out the battery-holder and change the batteries paying
attention to the polarity indicated. Without batteries the instrument switches off: in this phase do not rotate the
hollow shaft to avoid loosing of correct quota. As soon as the batteries are fitted inside, the instrument
switches on with the same value on the display as at the moment of the switching off and if the shaft has not be
moved the value will be correct. In case the shaft is moved during the switching off, to re-establish the correct
measure its necessary to repeat the adjustment proceeding.
Data: 13/01/16
file: F20_ing.doc
pag 6/8