Digilock Next Mech Ürün Kılavuzu - Sayfa 2

Kilitler Digilock Next Mech için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. Digilock Next Mech 3 sayfaları.

Sayfayı Yazdır
Digilock Next Mech Ürün Kılavuzu

Operating Instructions

Operate with a Combination

To Lock:
1.
Close the door.
2.
Turn the knob to the locked
Accommodates door
3.
Scramble the combination.
thickness up to 20 mm

Operate with a Manager Key

Spacer required* for door
thickness less than 8 mm
To Unlock with Manager Key:
Mounting plate
1.
Insert the Manager Key.
2.
Turn the knob to the unlocked
3.
Open the door.
Note: The Manager key cannot be inserted or removed when the knob is in
Mounting
the unlocked position.
Screws

Programming Instructions

Reset Combination
Note "M" on
1
Manager Key
Manager key
Removal key
Factory default combination 0-0-0-0
If the door is locked, use the Manager Key to
open the door.
1.
Using the Manager Key, turn the knob to
the locked
position.
2.
Remove the Manager Key.
4
The final code displayed is the current code. In
this example, the combination was 5-9-9-4 .
Product Guide
To Unlock:
1.
Enter the assigned 4-digit combination.
2.
position.
Turn the knob to the unlocked
3.
Open the door.
To Lock with Manager Key:
4.
Close the door.
5.
position.
Turn the knob to the locked
6.
Remove the Manager Key.
2
Reset Tool
Insert the Reset Tool into the four pin holes on
the rear of the unit.
5
Remove the Reset Tool and turn the knob to
the unlocked
Follow instructions to Assign a User Combination.
Dial Combo
position.
Cam in Locked Position
must overlap Strike
position.
Plate by at least ¼"
(6.35 mm)
Spacer Requirements
Door thickness
0 – 5 mm
5 – 8 mm
8 – 12 mm
12 – 16 mm
16 – 20 mm
position.
thickness up to 20 mm
Spacer required* for door
thickness less than 8 mm
Mounting plate
Assigned Use
Mounting
Screws
Mortise Hole Dimensions
Note "M" for
min. 6.35 mm
Manager on key
31.5 mm
Manager key
Removal key
Factory default combination 0-0-0-0
3
Screw type
*Spacer required
✓
M3×10
✓
M3×14
M3×10
M3×14
M3×18
Push in the Reset Tool and simultaneously turn
all dials until they stop.