FIAMA EP3 Kullanıcı Kılavuzu - Sayfa 5

Ölçüm Cihazları FIAMA EP3 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. FIAMA EP3 8 sayfaları. Battery-powered electronic position indicator

Sayfayı Yazdır

EP3

3) Activation mode of the keys

This parameter programs the functions associated with pressing the key once, if it is pressed

outside the programming menu.

The value to be set is a one-digit number for which a specific function is associated with each

value, according to the following table.

VALUE

Reset: reset function of the displayed value, by pressing the button the displayed value is set to

zero.

Preset: preset function of the displayed value; by pressing

becomes equal to the value in the

(when the digit on the right is set to 2).

Fast Preset: the fast setting of the displayed value on the display; by pressing and releasing the

button key the writing

of the preset parameter.

Then you can set a value, with the procedure seen previously. The set value becomes the value

shown on the display at the current position. This function is useful when the altitude on the

display needs to be corrected frequently.

4) Counting direction

It sets the counting direction, allowed values 0 or 1.

By setting 0, the displayed value increases turning the shaft clockwise.

By setting 1, the displayed value decreases turning the hollow shaft clockwise.

5) Counting saving

Allowed values 0-1.

Writing '1' forces the saving of the current position and configuration of the instrument in the non-

volatile memory. This function is only used to not lose the measured position if the battery is removed

for replacement.

Displayed value calibration

After having mounted the instrument on the machine and having set all the parameters, to view the

correct measurement on the display, it is necessary to reset or preset the displayed value.

Place the position of the shaft where the measurement to be displayed is precisely known (e.g.

mechanical stop position) or measure that point on the axis.

Program the parameter

and the

will appear, press again the button for about two seconds and set the measurement

to be displayed on the display. Confirm by holding down the button for about 5 seconds and the

measurement will appear on the display. If the calibration displayed value should be equal to zero,

instead of the preset it is possible to use the reset by setting the value '1' in the parameter

menu, then pressing the button the displayed value on the display will be reset to zero.

Now the instrument is calibrated, the parameter

avoid accidental reset/preset of the value.

Date: 30/10/23

Key disabled: no function will be performed when the key is

mm to inch conversion

parameter, which can be set immediately after

appears; by holding down the button it is possible to modify the value

with the value '3' and exit from programming . Now press the button

File: EP3_ing.doc

Function

pressed

Reset

Preset

the button the displayed value

must be restored to the desired value to

Electronic position indicator

Page: 5/8