FIAMA EP46RS Kullanım ve Bakım Kılavuzu - Sayfa 2
Ölçüm Cihazları FIAMA EP46RS için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. FIAMA EP46RS 12 sayfaları. Electronic hollow shaft display with serial output
Sayfayı Yazdır
Hollow shaft display with serial output
Manual purpose
This manual has been designed by the Manufacturer to provide the necessary information regarding the
EP43RS / EP46RS display to those who are authorized to carry out safely its installation, maintenance,
removal and disposal. All the necessary information for the buyers and planners can be found in the Sales
documentation. In addition to adopting good technical construction practices, the information should be read
carefully and strictly applied. Failure to observe this information could cause risks for the health and safety of
people and economical damage. This information, provided by the Manufacturer in the original language
(Italian) is also available in other languages to satisfy legislative and/or commercial needs. This manual must
be kept in good conditions by a responsible person in an ideal place so that it is always available for
consultation. In case this manual is lost or deteriorates, a replacement should be requested directly from the
manufacturer indicating the manual's code. This manual reflects the state of the instrument at the time of
input on the market: however the manufacturer reserves the right to make changes, add or improve the
manual without further notice.
Identification of the equipment
The identification label is applied on the instrument.
To determine the identification code of the instrument, consult the sales documentation.
Environmental conditions
Temperature range: min. 0°C, max. + 50°C.
It is forbidden to use the instrument other than for its specific use and in potentially explosive conditions or
where anti-explosive elements are required.
Storage
Here below are some references to be followed for the storage of the instrument:
Avoid environments with excessive humidity and those exposed to bad weather (avoid open areas).
Avoid putting the instrument directly on the ground.
Store the instrument in its original packaging.
Conformity declaration and EC marking
The instrument respects the following Communitarian Directives:
2014/30/EU Electromagnetic compatibility, 2011/65/EU RoHS.
Maintenance
The instrument does not need particular maintenance except cleaning, only with a soft cloth dampened with
ethyl alcohol or water. Do not use hydrocarbon solvents (petrol, thinners, etc.): the use of these products
could affect the proper function of the instrument.
Repairs should be done only and exclusively at the FIAMA technical assistance centre .
Calibrations and tests
It is advisable to calibrate the instrument periodically, once every working year.
To conduct calibration, follow the calibration procedure described in the present manual.
Technical Support
For any kind of technical assistance, contact the sales department of the Manufacturer directly indicating the
information given on the identification label, the number of hours used and the type of defect.
Manufacturer's responsibility
The manufacturer declines any responsibility in case of:
•
Using the instrument contrary to applicable national safety and accident-prevention laws.
•
Incorrect installation, inobservance of, or incorrect procedures in contrast with the instructions
provided in the present manual.
•
Defective electrical power supply.
•
Modifications or tampering.
•
Operations carried out by untrained or unqualified staff.
The safety of the instrument also depends on the strict observance of the procedures indicated in the
manual: always operate the instrument in its functioning capacity and carry out a careful routine maintenance.
•
All phases of inspection and maintenance should be carried out by qualified staff.
•
The configurations indicated in the manual are the only ones permitted.
•
Do not attempt to use the instrument in anyway which is contrary to the indications provided.
•
The instructions in this manual do not substitute but are a complement to the obligations of the
current legislation regarding safety laws.
Date: 06/04/21
File: EP4RS_4.1_ing.doc
EP43RS / EP46RS
Rev: 4.1
Page: 2/12