FIAMA P1X Manuel - Sayfa 3

Valf Konumlandırıcılar FIAMA P1X için çevrimiçi göz atın veya pdf Manuel indirin. FIAMA P1X 11 sayfaları.

Sayfayı Yazdır

function according to the following table:

KEY

NOTA BENE: in order to ease the association between the wished function and the corresponding number, on

the front panel next to every function indicator it is reported the number corresponding to the associated

function.

MANUAL AXIS MOVEMENT (MAN)

The manual function enables to move the axis forward/backward in slow/fast mode by pressing the

numerical keys according to the following table:

NB: in order to move the axis the EMERGENCY input must be closed.

ZERO SETTING/PRESETTING OR ZERO RESEARCH (ZERO)

Through this function it is possible to zero set or set at a wished value (preset) the dimension of the axis

or to carry out an automatic zero research (with encoder zero notch or zero micro) to zero set or preset

the dimension.

Manual zero setting or presetting

By pressing the E key or by enabling the

carry out a presetting of the dimension as a function of what was set in the constant

Automatic zero setting or presetting (zero research)

By enabling the START input in the terminal box (if the constant

page 7) the zero research is started; it occurs with the backward shifting of the axis at slow speed. When

the axis meets the zero notch the dimension is set to zero and the movement is interrupted.

In order to use this function it is necessary that the zero microswitch (or the proximity switch) is connected

to the

input of the positioner.

PRESET

IMMEDIATE POSITIONING AT A SINGLE DIMENSION (SING)

This mode was created to immediately position the axis at a given dimension without intervening on the

positioning programmes. Press the C key, enter the dimension through the numerical keypad, confirm by

pressing E and close the

about 2 seconds. If the

dimension. Once the axis reached the set position, it is possible to enable the

outputs according to what is set in the

AUX

data: 13/01/16

FUNCTION

ASSOCIATED FUNCTION

INDICATOR

Manual axis movement

MAN

Zero setting/presetting or zero research

ZERO

Immediate positioning at a given dimension

SING

Automatic/semiautomatic positioning

Writing of dimensions and positioning programmes

PROG

Setting of positioner machine parameters

COST

Inputs/outputs tests

TEST

Setting of the number of cycles to be carried out

CYCL

KEY

7 <<

9 >>

4 <

6 >

PRESET

input to start the movement of the axis or hold down the

START

input is closed, the positioner controls the motion to reach the set

EMERGENCY

file: P1X_ing.doc

AXIS MOVEMENT

Backward fast

Forward fast

Backward slow

Forward slow

input in the terminal box it is possible to zero set or to

constant (see page 6)

on page 7

is set to the proper value see

- key for

START

END OF POSITIONING

pag 3 di 11

and