FIAMA P1XT Series Manuel - Sayfa 8

Valf Konumlandırıcılar FIAMA P1XT Series için çevrimiçi göz atın veya pdf Manuel indirin. FIAMA P1XT Series 11 sayfaları.

21)Value of the analogue output for the speed Fast

The output value which corresponds to the speed Fast is stated in per cent of the maximum value and

that can be set-up from 1 to 100.

22) Value of the analogue output for the speed Slow

The output value which corresponds to the speed Slow is stated in per cent of the maximum value and

that can be set-up from 1 to 100.

23) Working way for output -10/+10V o 0/10V

Through this constant is possible to select the type of output: setting 0 (driving gear) the output goes from

-10V to +10V, positive voltage for the onward gear and negativ for the backward gear, setting 1 (inverter)

the output goes from 0 to +10V and the gear wise is discriminated by the relay of Forward/Backward.

By using the current output 4/20 mA set this constant to 1.

24) Dimensions lower limit

Due to safety reasons the positioner prevents the entry of dimensions lower than the value set in this

constant and interrupts the axis motion if during the positioning the dimension becomes lower than this

limit. Don't set values that are upper then the Upper Limit for the values (next constant) or the positioner

will not accept the start drives

25) Dimensions upper limit

As for the previous constant, the positioner prevents the entry of dimensions exceeding the value set in

this constant and interrupts the axis motion if during the positioning the dimension exceeds this limit. Don't

set the values that are lower then the Lower Limit for the values (previous constant) or the positioner will

not accept the start drives.

26) Display mode

Setting this function gives the possibility to convert the quota visualized on the display in a quota

expressed in inch fraction or degrees. Keeping pressed the key P for abt. 3 seconds is possible proceed

to a type of visualization to an other.

The constant

select the visualization needed according to the following table

data: 13/01/16

defines the type of conversion of the quota: using keys START- and START+

DISPLAY FUNCTION

From tenth of mm to thousandths of an inch

From tenth of mm to hundredths of an inch

From mm to hundredths of an inch

From mm to tenths of an inch

From cm to hundredths of an inch

Sexagesimal degrees with display in degrees and prime numbers

Sexagesimal degrees with display in degrees

file: P1X_T_ing.doc

disabled

From dm to inches

pag 8 di 11