Crescend C5 Series Manuel - Sayfa 8

Amplifikatör Crescend C5 Series için çevrimiçi göz atın veya pdf Manuel indirin. Crescend C5 Series 17 sayfaları. Continuous duty power amplifier

INSTALLATION

2.1.

This section contains installation recommendations, unpacking, inspection, and installation

instructions for the C5 Series of amplifiers. Carefully read all the material in this section

prior to equipment unpacking or installation. Also read and review the operating procedures

in Section 3 prior to installing the equipment. It is important that the licensee perform these

tasks correctly and in good faith. If applicable, carefully read Parts 73 and 74 of the Federal

Communications Commission (FCC) rules to determine how they apply to your installation.

DON'T TAKE CHANCES WITH YOUR LICENSE.

2.2.

Crescend Technologies recommends that proper AC line conditioning and surge

suppression be provided on the primary AC input to the +13.8 VDC power source. All

electrical service should be installed in accordance with the National Electrical Code, any

applicable state or local codes, and good engineering practice. Special consideration

should be given to lightning protection of all systems in view of the vulnerability of most

transmitter sites to lightning. Lightning arrestors are recommended in the service entrance.

Straight, short ground runs are recommended. The electrical service must be well

grounded. Each amplifier should have its own circuit breaker.

2.3.

This equipment has been operated, tested and calibrated at the factory. Only in the event

of severe shocks or other mistreatment should any substantial readjustment be required.

Carefully open the container(s) and remove the amplifier module(s). Retain all packing

material that can be reassembled in the event that the unit must be returned to the factory.

CAUTION:

Exercise care in handling equipment during inspection to

prevent damage caused by rough or careless handling.

Visually inspect the amplifier module for damage that may have occurred during shipment.

Check for evidence of water damage, bent or warped chassis, loose screws or nuts, or

extraneous packing material in the connector or fans. Inspect the rear panel connector for

bent connector pins. If the equipment is damaged, a claim should be filed with the carrier

once the extent of any damage is assessed. We cannot stress too strongly the importance

of IMMEDIATE careful inspection of the equipment and the subsequent IMMEDIATE filing

of the necessary claims against the carrier if necessary. If possible, inspect the equipment

in the presence of the delivery person. If the equipment is damaged, the carrier is your first

area of recourse. If the equipment is damaged and must be returned to the factory, write or

phone for a return authorization. Crescend may not accept returns without a return

authorization. Claims for loss or damage may not be withheld from any payment to

Crescend, nor may any payment due be withheld pending the outcome thereof. WE

CANNOT GUARANTEE THE FREIGHT CARRIER'S PERFORMANCE.

040003A001 Rev C