crescendo SYMPHONY S1 Plus Kullanıcı El Kitabı - Sayfa 9
Amplifikatör crescendo SYMPHONY S1 Plus için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. crescendo SYMPHONY S1 Plus 12 sayfaları. High performance
Sayfayı Yazdır
S6 MULTI-CHANNELS INPUT & OUTPUT CONNECTION
RCA INPUTS
Connect preamp signal cables from the source or
the headunit to RCA input.
GAIN ( 6V - 0.2V )
Matching the output voltage of the headunit's
RCA line-outs to amplifier's input.
HIGH PASS FILTER ( 20Hz - 8KHz )
Control the high pass filter frequency for the speaker
outputs.
Select HPF ON/OFF switch
GROUND ( GND ) & POWER ( +12V )
The power and ground will accommodate 4 guage
wire.
Use high quality pure copper wire only.
REMOTE ( REM )
REM connector will accept wire sizes from12 to 16
guage.
This terminal is used to remotely turn-on and turn-off
the amplifier when +12V DC is applied.
POWER & PROTECT LED
POWER LED ; Blue-lit shows correct operation.
PROTECT LED : Red-lit shows general malfunction,
faulty connection, or thermal protection.
LOW PASS FILTER ( 50Hz - 8KHz )
Control the low pass filter frequency forthe speaker
outputs.
Select LPF ON/OFF switch
MODE ( CH2 / CH4 / CH6 )
Select CH2 mode for a single pair of RCA inputs on CH1&2
to activate all 4 speaker outputs. ( No Y splitter needs )
Select CH4 mode for 2 pairs of RCA inputs and standard
speaker outputs.
Select CH6 mode for 3 pairs of RCA inputs and standard
speaker outputs.
REMOTE CONTROL ( OPTIONAL )
Use this to control level of the amplifier from
your driver's seat.
CLIP LED ( CH1/2, CH3/4, CH5/6 )
When input signal is close to clipping level. CLIP LED
begins to light up.
At full clip, the protection LED will light up.
SPEAKER TERMINAL BLOCK
Connect speaker cables from speaker terminal block
to full range speakers
Full range speakers impedance should be checked
carefully.
S6 minimum impedance is 2 ohm stereo or
4 ohm bridged.