Accusplit AE2720 Talimatlar

Adımsayar Accusplit AE2720 için çevrimiçi göz atın veya pdf Talimatlar indirin. Accusplit AE2720 1 sayfaları. Ae2700 series
Ayrıca Accusplit AE2720 için: Talimatlar (1 sayfalar)

Sayfayı Yazdır

AE2720 Pedometer

INSTRUCTIONS

Congratulations on taking the first step to wellness

with your purchase of an ACCUSPLIT pedometer.

It's easy to set up your new pedometer.

Just follow the steps below, and start walking!

HOW TO OPEN YOUR PEDOMETER

See diagrams at right.

The cover must be closed for the

pedometer to work.

WEARING YOUR PEDOMETER

Gently slide the pedometer onto

your belt or the top edge of your

pants or skirt. It should fit snugly

and level, above one knee. The

strong polycarbonate clip makes

it easy.

Note: The pedometer should be as vertical as possible.

Walkers with larger stomachs may find it helpful to wear

the pedometer farther back on the body, toward one hip.

The cover must be closed for the pedometer to work.

To avoid losing or dropping your pedometer, use the

included leash and clip to fasten the pedometer securely

to your clothing.

ATTACHING THE LEASH

Attach the pedometer to the

leash by looping the leash

through the pedometer leash

slot. Next, loop the leash

through the metal clip, then

clasp the waistband of your

clothing with the pedometer

belt clip.

Note: You can also use a safety

pin to fasten the leash to

your clothing, loop the leash

through your belt or belt loop,

or use a badge holder.

ACCUSPLIT, Inc. • 6120 Stoneridge Mall Rd., Suite 210 • Pleasanton, CA 94588 USA

800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • [email protected]

yes

First, loop the

pedometer leash slot

Next, loop the metal

clip, then clasp clothing

then put into pocket

Or, loop a belt or belt loop

DISPLAY MODES

• STEP: STEP mode shows

your step count since last reset,

up to 1,000,000 steps.

•

: ACTIVITY TIMER

◯

MODE shows total activity

time in minutes and seconds

since last reset. The timer runs

automatically whenever steps

are being recorded.

VIEWING YOUR RESULTS

Once you put on your pedometer with the cover closed,

it will automatically begin to record your steps, and

activity time. Repeatedly press the red MODE button to

cycle through the pedometer modes:

STEP → ACTIVITY TIMER → STEP

2-STEP DELAY FILTER

ACCUSPLIT has added a "2 step delay" filter to this

pedometer, to weed out false steps caused by tapping

the foot, sitting down, etc. The filter is set to "2 steps,"

meaning that the unit will wait to start counting steps

until more than two steps have been recorded. When

you are beginning a walk, the display will not show any

steps for a few seconds. After the unit has sensed three

steps, the display will register all of those steps at once,

and keep counting from that point.

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily. To reset:

press and hold the white RESET button for at least 2

seconds.

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to

replace the battery. Your pedometer uses one Type L1142

(LR43) 1.5 volt silver oxide battery.

To replace:

1. Insert a coin into the slot on the front of the

case, and twist counterclock-wise to loosen

the battery door.

2. Remove battery door and take out the old

battery. Replace it with a new battery. The

battery's positive (+) terminal should be

FACE UP while you put it into the

pedometer.

3. Put the battery door back on and twist the

coin clockwise to tighten.

Eat Right! Walk More!

Or, loop a

badge holder,

(Badge holder

not included)

The ACCUSPLIT Lifestyle

9789

�

▶

STEP

ACCUSPLIT EAGLE

Red:

White:

MODE

RESET

Live Well!

970-076B

10/08