Accusplit Eagle 1620 Kullanım Talimatları
Adımsayar Accusplit Eagle 1620 için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Accusplit Eagle 1620 1 sayfaları. Accusplit activity pedometer operating instructions
Congratulations on taking the first step to wellness with your purchase
of an ACCUSPLIT pedometer. It's easy to set up your new pedometer.
WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer
onto your belt or the top edge of your pants or skirt. It should
fit snugly and level, above one knee.
Note: The pedometer should be as vertical as possible. Walkers
with larger stomachs may find it helpful to wear the pedometer
farther back on the body, toward one hip.
The cover must be closed for the pedometer to work. To avoid
losing or dropping your pedometer, use the included leash and
clip to fasten the pedometer securely to your clothing.
Attaching the Leash: Attach the pedometer to the leash by
looping the leash around the pedometer belt clip. Next, clasp the
waistband of your clothing with the attached metal clip. You can
also use a safety pin to fasten the leash to your clothing, loop
the leash through your belt or belt loop, or use a badge holder.
First, loop the
pedometer clip
Next, loop the metal clip,
then clasp clothing
Or, loop a belt or
belt loop
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it will
automatically begin to record your steps.
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label inside the lid of the pedometer.
ACCUSPLIT, Inc. • 6120 Stoneridge Mall Rd., Suite 210 • Pleasanton, CA 94588 USA
800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • [email protected]
ACCUSPLIT®
EAGLE
ACTIVITY PEDOMETER
OPERATING INSTRUCTIONS
Just follow the steps below, and start walking!
Or, loop a
badge holder, then
put into pocket
(Badge holder not included)
Eat Right! Walk More! Live Well!
The ACCUSPLIT Lifestyle
1620
™
DISPLAY MODES
• STePS: Counts steps taken since last ReSeT.
Reset daily to count each day's steps.
STEP
TW15MG
ACCUSPLIT
AUTO MOVEMENT SENSOR
1. To filter out random movements, the unit remains in standby mode until
5 continuous steps are registered. Only then are the 5 steps calculated in,
and an Active indicator "▲" appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds the timer pauses
and the unit switches to standby status (Active indicator "▲" disappears)
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset: Press and hold yellow
ReSeT button for at least two seconds to reset to zero.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to replace the battery.
Your pedometer uses one Type LR43 (L1142) 1.5 volt alkaline battery. To
replace:
1. Insert a coin into the slot on the bottom of the case, and twist counter-
clockwise to loosen the case front. Lift case front away.
2. Using a pen or other thin object, push battery sideways out of its holder.
Replace it with a new battery. The battery's positive (+) terminal should
be FACe UP while you put it into the pedometer.
3. Align case front over the pedometer and press gently to
snap cover back into place, starting with top.
REGISTER NOW
Please return
your AE1620 Registration to the
Repair Center address in the
warranty, and we will let you
know about future products.
MY
425 I
10K-A-DAY
™
1620
EAGLE
RESET
Email (preferred)
User
Yellow:
ReSeT
970-066