Cisco 1503 Yazılım Kılavuzu - Sayfa 8

Anahtar Cisco 1503 için çevrimiçi göz atın veya pdf Yazılım Kılavuzu indirin. Cisco 1503 49 sayfaları. Cisco systems switch user manual

Configuring the Hub

Configuring the hub takes place in three major steps:

Entering Administrator Mode

Configuring IP and SNMP Parameters

Configuring the SNMP Management Station

All of the commands used in the configuration steps are fully explained in the section

"Command Summary" later in this chapter.

Entering Administrator Mode

Step 1

Step 2

Step 3

Step 4

3-8

Cisco Micro Hub User Guide

Connect a console by following the instructions in the section "Connecting the

CONSOLE Port" in the chapter "Installing Your Hub" or start a Telnet session

with the hub.

Turn the hub ON by setting the power switch to the ON ( | ) position.

After a few seconds, you will see the user prompt. Use the enable command to

enter administrator mode:

Hub> enable

After entering the command, you will be prompted to enter the administrator

password. If the administrator password has not been set, you can enter

administrator mode by pressing the Return key, as shown below:

Hub> enable

Password: <Return>

Hub#

If the administrator password has not been set, you should set it following

Note

the steps in the section "Setting the Administrator Password" earlier in this

chapter. Record the password in a secure location.

The pound sign (#) after the prompt indicates that you are in administrator mode

and can enter the commands to configure the hub for IP and SNMP parameters.