Cisco 200E Series Hızlı Başlangıç Kılavuzu - Sayfa 9

Anahtar Cisco 200E Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 200E Series 13 sayfaları. Advanced smart switches

MiniGBIC (if present)—The miniGBIC (gigabit interface converter) ports are

connection points for miniGBIC modules, so the advanced smart switch

can uplink to other switches by using optical fiber.

• MiniGBIC ports are compatible with Cisco miniGBIC modules MGBSX1,

MGBLH1, MGBLX1, MGBBX1, MFELX1, MFEFX1, and MFEBX1, as well as

other brands of miniGBIC modules.

• MiniGBIC interface is a combination port shared with one other RJ-45

interface. When the MiniGBIC is active, the adjacent RJ-45 port is

disabled.

• The LEDs of the corresponding RJ-45 port light to respond to the

miniGBIC interface traffic.

Front Panel LEDs

System LED—(Green) Lights steady when the switch is powered on.

Flashes when booting, performing self tests, and acquiring an IP address. If

the LED flashes Amber, the switch has detected a hardware failure.

LINK/ACT LED—(Green) Located on the left of the port. Lights steady

when a link between the corresponding port and another device is

detected. Flashes when the port is passing traffic.

The System and LINK/ACT LEDs are on each model of the switch.

OTE

The following LEDs are only present on switch models that have those

capabilities:

PoE (if present)—(Amber) Located on the right of the port. Lights steady to

indicate that power is being supplied to a device attached to the

corresponding port.

100M LED (if present)—(Green) Located on the right of the port. Lights

steady when another device is connected to the port, is powered on, and a

100 Mbps link is established between the devices. When the LED is off, the

connection speed is under 100 Mbps or nothing is cabled to the port.

Gigabit LED (if present)—(Green) Located on the right of the port. Lights

steady when another device is connected to the port, is powered on, and a

1000 Mbps link is established between the devices. When the LED is off,

the connection speed is under 1000 Mbps or nothing is cabled to the port.

MiniGBIC (if present)—(Green) Located on the right of the port. Lights

steady when a connection is made through the shared RJ-45 port. Flashes

when the port is passing traffic.

The switch can be reset by inserting a pin or paper clip into the reset

opening. See

"Returning the Device to the Factory Default Settings"

details.

200E Series Advanced Smart Switches

for