Cisco 3020 - Cisco Catalyst Blade Switch Kurulum Kılavuzu - Sayfa 17

Anahtar Cisco 3020 - Cisco Catalyst Blade Switch için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco 3020 - Cisco Catalyst Blade Switch 21 sayfaları. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Ayrıca Cisco 3020 - Cisco Catalyst Blade Switch için: Başlangıç Kılavuzu (37 sayfalar), Başlangıç Kılavuzu (31 sayfalar), Quickspecs (12 sayfalar), Yayın Notu (41 sayfalar), Yayın Notu (27 sayfalar), Yayın Notu (23 sayfalar), Yayın Notu (21 sayfalar)

Sayfayı Yazdır
Cisco 3020 - Cisco Catalyst Blade Switch Kurulum Kılavuzu
Chapter 2
Switch Installation
Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear
Step 4
of the slot. (See
Figure 2-11

Removing SFP Modules from SFP Module Slots

To remove an SFP module from a module receptacle, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the enclosure.
Step 1
Step 2
Disconnect the cable from the SFP module.
For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
Tip
For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the
Step 3
optical interfaces clean.
Unlock and remove the SFP module, as shown in
Step 4
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver
or other long, narrow instrument to open the bale-clasp latch.
Figure 2-12
1
OL-8914-02
Figure
2-11.)
Installing an SFP Module into an SFP Module Slot
S Y S T
S T A T
1 7
D L X
U ID
S P D
M O D E
C O N S
W S -C B
O L E
S -3 0 2 0
2 0
-H P Q
Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver
S Y S T
S T A T
1 7
D L X
U ID
S P D
M O D E
C O N S
W S -C B
O L E
S -3 0 2 0
2 0
-H P Q
Bale clasp
1 7 x
1 7 x
2 1 x
1 7
1 8
1 9
2 0 x
2 0
2 4 x
1 8 x
Figure
2-12.
1 7 x
1 7 x
2 1 x
1 7
1 8
1 9
2 0 x
2 0
2 4 x
1 8 x
1
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
Installing and Removing SFP Modules
2 3 x
2 4 x
2 3 x
2 4 x
2-17