Byetta PEN Kullanıcı Kılavuzu - Sayfa 9

İnsülin Kalemi Byetta PEN için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Byetta PEN 12 sayfaları.

Sayfayı Yazdır

STEP A Check the Pen

• Wash hands prior to use.

• Check pen label to make sure it is

your 10 mcg pen.

• Pull off the blue pen cap.

STEP B Attach the Needle

•

Remove paper tab from outer

needle shield.

•

Push outer needle shield

containing the needle straight

onto the pen, then screw

needle on until secure.

STEP C Dial the Dose

•

Check that the

is in the

dose window. If not, turn

dose knob away from you

(clockwise) until it stops and

the

is in the dose window.

Note: If you cannot turn the dose knob away from you to the

Section 4 of this user manual.

STEP D Prepare the Pen

•

Point the needle of the pen up

and away from you.

Note: If you do not see liquid after 4 times, see Commonly Asked Questions, number 3, in Section 4 of this user manual.

BYETTA

(exenatide) injection

ONE-TIME-ONLY NEW PEN SETUP

• Check BYETTA in the cartridge.

The liquid should be clear,

colorless, and free of particles.

If not, do not use.

•

Pull off outer needle shield.

Do not throw away.

•

Pull dose knob out until it

stops and the

dose window.

PUSH & HOLD

•

Use thumb to firmly push

injection button in until it

stops, then continue holding the

injection button in while slowly

counting to 5.

•

If you do not see a stream or

several drops come from the

needle tip, repeat Steps C & D.

Note: Small air bubbles in the

cartridge are normal.

•

is in the

, see Commonly Asked Questions, number 7, in

•

Pull off inner needle shield

and throw away. A small drop

of liquid may appear. This is

normal.

Turn dose knob away from

you until it stops at

Make sure that the 10 with

the line under it is in the

center of the dose window.

Pen preparation is complete

when the

is in the center

of the dose window and

you have seen a stream or

several drops come from the

needle tip.